COBURN 61600 Hideaway Jointing Kit Instruction Manual
- June 3, 2024
- COBURN
Table of Contents
61600 Hideaway Jointing Kit
Instruction Manual
61600 Hideaway Jointing Kit
- Remove and discard end plates from “door opening” end of each header.
- Cut 22mm (7/8″) from length of each header (wood part only) where discarded end plates had been located. Cut ends square to keep header straight when joined.
Butt cut ends together and insert “U” channel aligning cut ends of headers with center mark stamped in channel. Using channel as guide, drill two 4.7mm (3/16″) holes through headers at outer channel holes. Insert screws through
-
these holes and into top plate on top of header.
Tighten, forming a one-piece header. -
Drill a 6.3mm (1/4″) hole at channel center where header ends meet to enable the lag screw to be fastened into rough header for increased center support.
-
Insert stops into track and leave loose until
Coburn Sliding Systems Limited, Unit1, Cardinal West, Cardinal Way,
Godmanchester PE29 2XN
Tel: +44 (0)208545 6720, E-mail:
sales@coburn.co.uk
www.coburn.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>