SIEMENS TW86104P Kettle Sensor for Senses Instruction Manual

: June 9, 2024
: SIEMENS

Table of Contents

SIEMENS TW86104P Kettle Sensor for Senses
Safety instructions
Parts and operating controls
INSTALLATION
Keep warm setting
Cleaning and maintenance
Troubleshooting
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SIEMENS TW86104P Kettle Sensor for Senses

SIEMENS-TW86104P-Kettle-Sensor-for-Senses-prodact-img

Safety instructions

Please read and follow the operating instructions carefully and keep them for later reference. Enclose these instructions when you give this appliance to someone else. This appliance is intended for domestic use only.

Danger of electric shock

Only use the appliance indoors at room temperature and up to 2000 m above sea level. The appliance may only be connected to a power supply with alternating current via a correctly installed socket with earthing. Ensure that the protective conductor system of the domestic supply has been correctly installed. Connect and operate the appliance only according to the type plate specifi cations. To avoid potential hazards, repairs such as replacing a damaged cable must only be carried out by our customer service personnel. This appliance can be used by children aged from 8 years and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Keep children under 8 years of age away from the appliance and connecting cable and do not allow them to use the appliance. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 years and supervised.Avoid spillage on the connector. Never immerse the appliance, base or mains cable in water. Use the kettle only with the included base. Use only if power cord and appliance show no signs of damage. Should a fault occur, pull the plug or disconnect from the mains immediately.

Risk of fire

Do not place the base or kettle on or near hot surfaces, e.g. hobs. Avoid spatters of grease as the plastic may be damaged.

Risk of scalding

The appliance heats up during use. Make sure you only pick it up by the handle and do not open the lid until the appliance has cooled down. Only use the appliance when the lid is engaged. If the appliance is fi lled above the “max” marking, there could be a risk from splashes of boiling water.

Risk of burns

After the use the heating element surfaces and warming plate can be subjected to residual heat.

Do not use near water contained in bath tubs, sinks or other containers.

Risk of suff ocation

Do not allow children to play with packaging material.

Risk of injury

A misuse of the appliance can potentially lead to injury. Congratulations on purchasing this Siemens appliance. You have acquired a high-quality product that will bring you a lot of enjoyment.

Parts and operating controls

Kettle (with water level indicator)
Lid
Lid release button
ON/OFF O switch
Temperature indicator (illuminated)
+ – button (temperature setting)
U button (keep warm)
Limescale filter (removable)
Base
Cable tidy

INSTALLATION

SIEMENS-TW86104P-Kettle-Sensor-for-Senses-fig-3

Important

Use the kettle 1 only with its included base 9.

Only fill the kettle with water. Milk and instant beverages will burn and damage the appliance. Never operate the kettle 1 without water and do not overfill it; observe the min and max markings. If the kettle is too full, the water will boil over!

Boiling water

Fill the kettle with fresh water through the spout or the open lid 2 (press lid release button 3).
Check the amount by reading the water level indicator markings (min and max).
Close the lid 2 until it locks and place the kettle 1 on the base 9.
Press the O ON/OFF switch 4. The kettle emits a signal, and the factory-set temperature (100°C) lights up. The water is being heated.
By pressing button 6 + or – you can set the temperature to ca. 70°C, ca. 80°C, ca. 90°C or ca. 100°C.
When the water has reached the selected temperature, the kettle will switch off automatically, the temperature indicator 5 goes off, and a signal sounds.

Note: The selected temperature can be changed at any time while the kettle is heating up. While the kettle heats up, the current temperature lights up; the preset temperature flashes until it has been reached. If the temperature cannot be set, this indicates that the water in the kettle is hotter than the desired temperature. The current temperature will light up. You can turn off the kettle at any time by pressing the O ON/OFF switch 4 again.

Warning: If you remove the kettle 1 from the base and replace it before the heating process is over, the kettle will not continue to heat the water. The selected settings will be lost (reset to factory setting).

N.B.: Use the kettle only while the lid 2 is closed and the limescale filter 8 is in place. For physical reasons, the base 9 may collect some condensation water. This is normal; it does not mean that the kettle 1 leaks. When you set the temperature to 100°C, the kettle will turn off only after the water has reached the boiling point, i.e. it will bubble for a short period of time. After boiling, let the kettle cool down for 5 minutes before refilling it with water. Do not turn on the appliance if the kettle 1 is empty, otherwise the overheat control will engage and the appliance will switch itself off automatically.

Keep warm setting

You can turn on the keep warm with any temperature setting. Press button 7. U lights up, and the function is activated. To turn it off, press button 7 again. The U indicator goes off.

Note: The keep warm feature switches off automatically after 30 minutes. The kettle emits a signal.

Cleaning and maintenance

Risk of electric shock

Never immerse the device in water or place it in the dishwasher! Do not steam- clean the appliance.

Before cleaning, unplug the appliance from the power outlet.
Clean the outside of the kettle 1 and base 9 with a damp cloth. Do not use strong or abrasive cleaning agents.
Remove the limescale filter 8, soak it in a little vinegar, then rinse clean with clear water.
Rinse the kettle 1 and the limescale filter 8 with clear water.

Tip: Clean the stainless steel surface with a commercial stainless steel care product.

Descaling

Regular descaling
makes your kettle last longer;
ensures proper function;
saves energy.
Descale the kettle 1 with vinegar or a commercial descaling agent.
Fill the kettle 1 with water up to the 1.5 mark and bring to a boil. Next, add a small amount of white vinegar and let it sit for several hours. You can also use a commercial descaling product and follow the manufacturer’s instructions.
Rinse the kettle 1 and the limescale filter 8 with clear water.

Warning: Never use hard objects to remove limescale residue as this will damage the seal.

Tip: If you use the kettle daily, descale more frequently.

Troubleshooting

The kettle does not heat up; the temperature indicator 5 does not light up.
The overheat control has tripped.
Let the kettle 1 cool down for some time so that the appliance can be switched on again.
The unit turns off before the water comes to a boil. The kettle contains too much scale.
Descale the kettle as per the instructions.

Great Britain

BSH Home Appliances Ltd. Grand Union House Old Wolverton Road Wolverton Milton Keynes MK12 5PT To arrange an engineer visit, to order spare parts and accessories or for product advice please visit www.siemens-home.bsh- group.uk or call Tel.: 0344 892 8999 Calls are charged at the basic rate, please check with your telephone service provider for exact charges

US United States of America
BSH Home Appliances Corporation 1901 Main Street, Suite 600 Irvine, CA, 92614 Tel.: 866 447 4363 toll-free Fax: 949 437 7000 mailto:siemens-usa-questions@ bshg.com www.siemens-home.bsh- group.com/us

SE Sverige, Sweden
BSH Home Appliances AB Landsvägen 32 169 29 Solna Tel.: 0771 11 22 77 local rate mailto:Siemens-Service-SE@bshg.com www.siemens-home.bsh-group.com/se

NL Nederlande, Netherlands
BSH Huishoudapparaten B.V. Taurusavenue 36 2132 LS Hoofddorp Storingsmelding: Tel.: 088 424 4020 Fax: 088 424 4845 mailto:siemens- contactcenter@bshg.com Onderdelenverkoop: Tel.: 088 424 4020 Fax: 088 424 4801 mailto:siemens- onderdelen@bshg.com www.siemens-home .bsh-group.nl