PRODEMAND 2015 Ford Focus SE Instruction Manual

2015 Ford Focus SE
Instruction Manual

2015 Ford Focus SE

REMOVAL AND INSTALLATION > TRANSMISSION CONTROL MODULE (TCM)
NOTE: For information on Ford Color Coded Illustrations refer to COLOR- CODING – FORD .
Special Tool(s) / General Equipment
Ford Diagnostic Equipment
Materials

REMOVAL AND INSTALLATION > TRANSMISSION CONTROL MODULE (TCM) > REMOVAL

1. Position the vehicle on a hoist. Refer to: Jacking and Lifting – Overview .

2. NOTE: TCM Programming is NOT necessary if the TCM is being re-used. Download the module information to the diagnostic tool using the Programmable Modules Installation routine.

3. Remove the air deflector.
   Printer Friendly View
   **** Courtesy of FORD MOTOR COMPANY

4. Remove the underbody shield.
   Courtesy of FORD MOTOR COMPANY

5. Push up on the front of the wiring routing bracket to release the retainer and position it aside.
   

6. Courtesy of FORD MOTOR COMPANY
   NOTE: Make sure that the terminals or pins/sockets of the transmission control module (TCM) and the TCM electrical connector are not bent or damaged.
   Disconnect the wiring, remove the wiring retainers from the wiring harness and position aside the wiring harness. Remove the TCM bolts.
   **Courtesy of FORD MOTOR COMPANY **

   ---

7. Remove the TCM.
   Courtesy of FORD MOTOR COMPANY

   ---

8. Remove and discard the O-ring seals.
   **** Courtesy of FORD MOTOR COMPANY

9. NOTE: Make sure that the mating faces are clean and free of corrosion and foreign material.
   Inspect the TCM mating surface for corrosion and debris.

REMOVAL AND INSTALLATION > TRANSMISSION CONTROL MODULE (TCM) >

INSTALLATION

1. NOTE: Make sure that the mating faces are clean and free of corrosion and foreign material.
   NOTE: Install new O-rings.
   Install new O-rings and lubricate with transmission fluid.
   Material: Motorcraft ® Dual Clutch Transmission Fluid / XT-11-QDC (WSS- M2C200-D2).
   Courtesy of FORD MOTOR COMPANY

2. NOTE: Do not force the TCM onto the transmission or damage may occur.
   NOTE: Make sure the TCM sits flush on the transmission or damage can occur.
   Install the TCM on the transmission. Apply light pressure to seat the O-rings. If the TCM does not push in place with light pressure, remove the TCM and slightly turn  he TCM gears and retry  installing the TCM on the transmission.

3. NOTE: Make sure that the terminals or pins/sockets of the transmission control module (TCM) and the TCM electrical connector are not bent or damaged.
   install the  olts and the wiring. Torque: 20 lb.ft (27 Nm)

4. Install the wiring routing bracket.
   Courtesy of FORD MOTOR COMPANY
   

5. Install the underbody shield.
   Courtesy of FORD MOTOR COMPANY

6. Install the air deflector.
   

7. NOTE: New units must be configured using the Programmable Modules Installation Routine in the diagnostic tool.
   Upload the module information from the diagnostic tool to the module using the Programmable Modules Installation routine. Use the General Equipment: Ford Diagnostic Equipment

8. Using the diagnostic tool, perform the TR Sensor Adaptive Learn and Clutch Adaptive Learn routines found in the TCM Adaptive Learning sub-menu.

https://www1.prodemand.com/Print/Index?content=tabs&module=true&tab=true&terms=true&ymms=false&selectorMode=&className=

References

• Printer Friendly View

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>