FSi XM311K 31 Inch True 4K HDR Mastering Monitor User Guide
- June 4, 2024
- FSi
Table of Contents
FSi XM311K 31 Inch True 4K HDR Mastering Monitor
XM W-OLED Quick Start Guide – FW.2.1.24
Color System
The monitor features 5 Color System selections: DEFAULT, GaiaColor,
LightSpace, CalMAN, and NONE. On the XM652U, XM651U, XM650U, XM552U, and
XM551U the factory calibrations are stored in the DEFAULT Color System.
LightSpace and CalMAN Color System options are provided as additional memory
place holders to store custom end-user calibrations using LightIllusion
(Light-Space / ColourSpace) or CalMAN calibration software. The GaiaColor
selection is reserved for future development and should not be used with
firmware version 2.1.24. Please leave the ColorSystem set to Default unless
you have specifically saved your own user generated calibration LUTs to the
LightSpace or CalMAN memory banks.
Basic settings for the most commonly used configuration on XM W-OLED models
are provided below
For Rec709 2.4 SDR
- Color System: Default
- LUT Mode: Normal Range: Video
- Range 64-940
- Gamut: BT.709
- Luminance Mode: 100
For P3-ST2084 HDR
- Color System: Default
- LUT Mode: Normal Range: Full
- Range 0-1023
- Gamut: P3-ST2084
- Luminance Mode: HDR
Please note that in the DEFAULT Color System if factory LUTs have not been overridden the gamut op-tion DCI P3 will target a DCI white balance of x=0.314, y=0.351 while the P3-ST2084 option will target a white balance of x=0.3127, y=0.3290.
Connectivity
The preferred configuration is single link 12Gbps or 6Gbps SDI. Quad Link 3Gbps and 1.5Gbps signals are also supported, but must be manually selected from the Video Menu. 4K and UHD over 3G dual-link, 3G quad-link, and 1.5G quad-link should be formatted as Square Division (SQ).
FW 2.1.24 Known Issues List
The following are known issues scheduled to be addressed in future firmware
release:
TimeCode reader does not update in real time.
Two Sample Interleave (2SI) formatted signals are not currently supported.
Square Division formatting should be used.
DisplayPort is not currently enabled.
For further support please download the complete user manual or contact
Support by email or phone:
Support@FlandersScientific.com or
+1.678.835.4934