our generation PMS 676 C Seaside Beach House User Manual
- June 3, 2024
- our generation
Table of Contents
our generation PMS 676 C Seaside Beach House
Battery installation
Battery Compartment Location
- The battery compartment is located at the top left corner of the folding bed.
Step
- Open the battery cover with a screw driver. Install 3 x 1.5V AA batteries and follow the polarity.
- Product is shipped on Try Me Mode. Slide the switch to Play Mode.
Folding bed
Open
- Please remove all packaging materials before giving to children.
Stove
- A. Turn A knobs to activate burner sizzling sounds.
- B. Turn B knobs to activate timer sound.
- C. Press burners for sizzling sound. Press again to stop.
- D. Heart light goes on when burners are pressed.
Sounds & Projector
- A. Press button for cricket sound.
- B. Press button for sea birds sound.
- C. Press button to project stars onto the ceiling.
- Colors:
- Press once for green color.
- Press again for yellow color.
- Press again for red color.
- D. Press button for ocean sound
- E. Press button for rain sound.
Sink
Press down on drain for garbage disposal sound.
BATTERY ADVICE
Requires 3 X AA (1.5V ) Batteries included. Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the toy before being charged. Rechargeable batteries are only to be charged under adult supervision. Different types of batteries or new and used batteries are not to be mixed. Only batteries of the same or equivalent type as recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed from the toy. The supply terminals are not to be short-circuited.
ATTENTION: When the module’s functions lose performance, follow instructions carefully to install new batteries.
Waste electrical products and old batteries should not be disposed of with household waste. Help protect the environment by reusing, and recycling. Check with your local authority or retailer for recycling advice.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING: CHOKING HAZARD-Small parts. Not for children under 3 years.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>