our generation OG Off Roader 4×4 Vehicle for 18 Inch Dolls Instructions
- June 6, 2024
- our generation
Table of Contents
OG Off-Roader™
Instructions
QDID #: 136415/ 159135.
The product contains the Bluetooth play function, which can link to any smart device with Bluetooth V2.1 and above.
Bluetooth user guidelines: First time set up:
- Turn off all Bluetooth devices nearby. ei. speakers, phone, handsfree, Toy, Control devices……etc
- Press the jeep Bluetooth button (blue light will flash on to connect) Press again to turn off.
- Turn on your phone’s Bluetooth
- Search for “OG off-roader”, select. The phone is now linked with Jeep and music will play.
Note: If the blue light is dimmed, its almost time to replace New Alkaline batteries.
Radio guidelines:
- FM (88-108Mhz Radio reception is very dependent on geographical location; This product is designed for use in regions with adequate radio reception and is not intended for regular radio use.
- If abnormal sounds are produced, push the car’s bottom power switch to “OFF” for 2 seconds and then push back to “Play”.
- Please read this instruction sheet carefully and keep it for future reference.
WARNING : CHOKING HAZARD-Small parts. Not for children under 3 years.
Print 1 solid color PMS 676 C
How to assemble back door
BATTERY ADVICE
- Requires 3 x AA (1.5V) batteries included.
- Batteries should only be replaced by an adult.
- Do not mix old and new batteries.
- Do not mix alkaline, standard or rechargeable batteries.
- Do not recharge non-rechargeable batteries.
- Rechargeable batteries are only to be charged under adult supervision.
- Rechargeable batteries are to be removed from the product before being charged.
- Ensure batteries are inserted with the correct polarity.
- Exhausted batteries should always be removed.
- The terminals should not be short-circuited. ATTENTION: When the module’s functions lose performance, follow instructions carefully to install new batteries.
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Warning : Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions : (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Shielded cables must be used with this unit to ensure compliance with the
ClassB FCC limits.
FCC RF Radiation Exposure Statement Caution: To maintain compliance with the
FCC’s RF exposure guidelines, place the product at least 20cm from nearby
persons.
The device must not be co-located or operating in conjunction with any other
antenna or transmitter.
“This device complies with FCC radiation exposure limits set forth for the
general population (uncontrolled exposure).
This device must not be collocated or operating in conjunction with any other
antenna or transmitter.”
Waste electrical products and old batteries should not be disposed of with household waste. Help protect the environment by reuse, recycling. Check with your local authority or retailer for recycling advice.
How to attach Suite Star Trailer and Horse trailer.
WARNING!: SMALL PARTS – CHOKING HAZARD. Not suitable for children under 3 years.
Please remove all packaging materials before giving to children.
Documents / Resources
| our
generation OG Off Roader 4x4 Vehicle for 18 Inch
Dolls
[pdf] Instructions
RFBD37279-5, RFBD372795, SLURFBD37279-5, SLURFBD372795, OG Off Roader 4x4
Vehicle for 18 Inch Dolls, OG Off Roader, 4x4 Vehicle for 18 Inch Dolls
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>