Kaysun KMB-01 Prodigy Multifunction Board Installation Guide
- June 3, 2024
- Kaysun
Table of Contents
Kaysun KMB-01 Prodigy Multifunction Board
The explanation of ports on multifunction board
-
Multi-function board scheme
-
Connection between indoor unit and Multi-function board scheme
-
Available ports and switches
- Rotary switch ENC3 and Dip-switch F1 is for Net address setting;
- Dip switch F2 is for On-off setting
-
F2 port on multi function board
Picture
| Dip- switch 1| Dip- switch 2|
ON-OFF port
| Unit’s Operation
---|---|---|---|---
|
ON
|
ON
| • ON-OFF port works as an ON/OFF button.
• By connecting the port,’OFF’ signal is sent to switch off the unit. You can switch on the unit with remote controller.
• By disconnecting the port, ‘ON’ signal is send to switch on the unit. You can switch off the unit with remote controller.
|
Restart with auto mode,24°C
|
ON
|
OFF
| • ON-OFF port works as an ON/OFF button.
• By disconnecting the port, ‘OFF’ signal is sent to switch off the unit. You can switch on the unit with remote controller.
• By connecting the port, ‘ON’ signal is send to switch on the unit.. You can switch off the unit with remote controller.
|
Restart with auto mode,24°C
|
OFF
|
OFF
| • When ON-OFF port is connected, unit shows CP and can’t work. And you can not control the unit with remote controller.
• When ON-OFF port is disconnected, unit works normally. And you can control the unit with remote controller.
|
Restart with previous setting
|
OFF
|
ON
| • When ON-OFF port is connected, unit works normally. And you can control the unit with remote controller.
• When ON-OFF port is disconnected, unit shows CP and can’t work. And you can not control the unit with remote controller.
|
Restart with previous setting
Installation
- Necessary parts
-
Step1: Open the Electrical box and take out the PCB
-
Step 2: Insert FRIMB-CABLE 2terminal into CN32 on the PCB
-
Step 3: Open the Display box and replace the old cable with FRIMB-CABLE1
-
Step 4: Install the Display box assembly and Electrical box assembly:
-
Step 5: Install the Support and Multi-function box:
-
Step 6: Connect all the cables, as the point 1.B shows:
-
Step 7: Neaten all the cables to finish the installation.
Aditional notes
Notes:
- Multi function board is compatible with wifi function and basic 4-wired controller at the same time, because wifi port and wired controller ports are connected to different sockets on the display board.
- Wall controller and centralized controller can not work at the same time. 3 – Wall controller compatible: KC – 03.2 SPS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>