SHEIN ZW-060A Wireless Headphone User Guide
- September 30, 2024
- SHEIN
Table of Contents
SHEIN ZW-060A Wireless Headphone
Product Information
Specifications:
- Compliance: Part 15 of FCC Rules
- RF Exposure: Meets general RF exposure requirement
- Portable Use: Can be used in portable exposure conditions without restriction
Product Usage Instructions
Interference Measures:
If interference occurs, follow these measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that of the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Compliance:
Operation is subject to the following conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirements. It can
be used in portable exposure conditions without restriction.
FAQ
Q: What should I do if there is interference with radio or television
reception?
A: Follow the provided measures to correct the interference. If the issue
persists, consult a dealer or radio/TV technician for assistance.
PARAMETER
- Version: V5.3+EDR
- Use Distance: 15m
- Using Time: 30h
- Charging Time: 2h
- Battery Capacity: 360mAh
- Dynamic Drivers: 40mm 32Ω
- Frequency Response: 20Hz-20kHz
- Charging Interface: Type-C
FUNCTION OF BUTTONS
- Long press to power on/power off/reject incoming call; click to play/pause music, answer/hang up call; double-click to dial the last dialed number
- Long press to decrease volume; click on the previous song
- Long press to increase volume; click to the next song
CONNECTION
Wireless mode
- Long press the multi-function button until the indicator light is on, and then the product is ready to connect
- Turn on your device, and select the model number/pairing name from the menu.
- After connecting successfully, you will hear “connected”.
Wired mode
Plug in the audio cable, then the product can be used as a wired headphone.
NOTICE
- Please fully charge the product for the first use.
- If the product needs to be unused for more than one month, please fully charge the product before storing it. During this period, it is recommended to fully charge the product every month which can greatly and effectively prolong the service life of the product.
- Please choose the charger produced by a formal manufacturer and certified by your local standards to charge the product.
SAFETY WARNING
- Do not dismantle or repair or modify this product for any reason.
- Do not place this product in the environment where the temperature is below 0°C or above 45°C.
- Do not expose this product to rain or moisture.
- Do not throw, to avoid damage caused by falling the product.
- Do not use oil or other volatile chemical liquids to wipe the product surface.
Alcohol can be used for product daily cleaning and maintenance.
FCC STATEMENT
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>