NEBULA D0450 Wireless Microphone User Guide

June 3, 2024
NEBULA

NEBULA D0450 Wireless Microphone User Guide
NEBULA D0450 Wireless Microphone

Installing the Batteries

Installing the Batteries

Powering On/Off

Powering On/Off

Pairing

Pairing instruction

 Make sure to enable the microphone of your projector via the settings menu.

Important Safety Instructions

Warning:

  • Replacement of a battery with an incorrect type can defeat a safeguard;
  • Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery can result in an explosion;
  • Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas;
  • A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction.

Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Specific Absorption Rate (SAR) information:
This product meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

RF Exposure Information and Statement.
The SAR limit is 4.0 W/kg averaged over one gram of tissue.
This device was tested for typical operations kept 0mm from your limbs. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with RF exposure requirements, and should be avoided.

The highest reported SAR value for use at your limbs is 0.227W/Kg.
The following importer is the responsible party
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: 1-800-988-7973

IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. This device may not cause interference, and
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

IC RF Statement:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction.

Specific Absorption Rate (SAR) information:
This product meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and  thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

RF Exposure Information and Statement.

The SAR limit is 4.0 W/kg averaged over one gram of tissue.
This device was tested for typical operations kept 0mm from your limbs. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with RF exposure requirements, and should be avoided.

  • The highest reported SAR value for use at your limbs is 0.227W/Kg.
Notice For EU and United Kingdom

 This product complies with the requirements of the European Community.

Declaration of Conformity

Hereby, Anker Innovations Limited declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit the Web site: https://uk.seenebula.com/ .

 This product complies with the radio interference requirements of the United Kingdom Declaration of Conformity

Hereby, Anker Innovations Limited declares that this device is in compliance with Radio Equipment Regulations 2017(SI 2017/1206). The full text of the UK declaration of conformity is available at the following internet address: https://uk.seenebula.com/ .

Do not use the Device in the environment at too high or too low temperature, never expose the Device under strong sunshine or too wet environment

The suitable temperature for the device and accessories is 0°C to 40°C It is recommended to supply the device in an environment with a temperature that ranges from 5 ℃ ~25℃.
When supplying, please place the device in an environment that has a normal room temperature and good ventilation.

RF exposure information:
The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=0 cm between the device and the human body. To maintain compliance with RF exposure requirement, use product that maintain a 0cm distance between the device and human body.

Frequency bands and power as below:

Function Bands Operation Frequency Max. Power
2.4G 2.4GHz 2402-2477 MHz EIRP: 8.06 dBm

The following importer is the responsible party (contract for EU matters):
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich, Germany

The following importer is the responsible party (contract for UK matters):
Anker Technology (UK) Limited | GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdom

 Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

Support

For FAQs and more information, please visit.

www.SeeNebula.com

  Support@SeeNubela.com

support@anker.com(日本)
support.mea@seenebula.com
(Middle East and Africa)

+1 (800) 988 7973 (US) Mon-Fri 6:15am – 5:00pm (PT)
+44 (0) 1604 936200 (UK) Mon-Sun 6:00 – 14:00 (GMT)
+49 (0) 69 9579 7960 (DE) Mo-Fr 8:00 – 16:00

©Anker Innovations Limited. All rights reserved. NEBULA and the NEBULA logo are trademarks of Anker Innovations Limited, registered in the United States and other countries. Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals