STELPRO SIBT1W Built In Mechanical Thermostat Kit for Electric Baseboard Instruction Manual
- September 26, 2024
- StelPro
Table of Contents
STELPRO SIBT1W Built In Mechanical Thermostat Kit for Electric Baseboard
Instruction Manual
BUILT-IN MECHANICAL THERMOSTAT KIT FOR ELECTRIC BASEBOARD
WHAT’S IN THE BOX
-
thermostat
-
knob
-
2 twist-on wire connectors
-
2 screws
THIS THERMOSTAT MUST BE INSTALLED BY AN ELECTRICIAN.
The thermostat should be installed before you wire your baseboard heater. If
the unit is already installed, turn off the power at the main electrical
panel.
-
Remove the front panel [A]. Unscrew the junction box cover on the side chosen for installation to remove it.
-
Push out the three knockouts on the cover.
-
Match the holes with the thermostat bracket and secure it in place with the two provided screws.
-
Wire the thermostat as shown on the diagram. Replace the cover and screw it in place to close the junction box.
Continue installation or reassemble the unit following the steps as shown in the baseboard owner’s manual. Install thermostat knob on the shaft.
STELPRO DESIGN INC.
1041 PARENT, ST-BRUNO-DE-MOMENTARILY,
QUEBEC, CANADA J3V 6L7
www.stelpro.com
1-844-STELPRO
Limited warranty: 1 year. See details at www.stelpro.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>