SINOX SOB0140 Universal Flat Wall TV Bracket Installation Guide
- September 25, 2024
- SINOX
Table of Contents
SOB0140 Installation Manual
1. Technical parameter
Size of flat panel TV: 10″~32″
Pitching angle: +15° ~ -15°
Maximum load: 20kg
Distance from wall: 48~377mm
Swing angle: ±90°
2. Part List
Please check the parts in the package in comparison with the following list. Make sure all of the parts are in the package. Never use defective parts. Never replace part with different specification.
(A) Self-tap screw(2) (B) Plastic anchors(2)
(C) ∅8 Flat washer(2) (D) M4*12 Screw(4)
(E) M512 Screw(4) (F) M612 Screw(4)
(G) Spanner S=13(1)
3. Installation and operation instructions
Note: please read the instructions carefully before installation!
STEP-1
- WALL
Step 1: Use the wall plate as a templet to drill two holes of ∅10mm diameter and 50mm depth in the vertical wall. Then wedge two plastic concrete anchors into the holes.
STEP-2
- WALL
Step 2: Fix the wall plate with two lag bolts through the mounting holes to install the wall plate on the vertical wall firmly.
STEP-3
- Bolts
Step 3: Using the tools to loosen the two bolts under the TV plate. Lift and remove the TV plate from the wall plate.
STEP-4
- TV
- D/E/F
Step 4: Install the panel TV on the TV fixed plate with suitable bolts selected from the parts bag. At last adjust the azimuth of the panel TV to a suitable position for watching.
STEP-5
- TV
- Bolts
Step 5: Lift the display together with the TV plate above the wall plate, Insert the TV plate to the wall plate as shown in the fig. Then using the tools to tighten the two bolts to fix them firmly.
STEP-6
Step 6: Tension is pre-set at the factory. Some time you may loosen nut to adjust tension. Tighten the nut after moving the TV to desired location.
STEP-7
Step 7: The view angle of the display can be adjusted between in the specific range as shown in the fig.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>