plumbworld B086DTPNPD White Gloss Bath Panel 750mm End Acrylic 5mm Instruction Manual
- September 24, 2024
- plumbworld
Table of Contents
plumbworld B086DTPNPD White Gloss Bath Panel 750mm End Acrylic 5mm
Panel Installation Instructions
-
Please note bath shown without bath supports for illustration purposes.
Using a cross headed screwdriver secure the bath panel clips to floor and the underside of the bath using the screws provided. Ensure that the panel clips are equally spaced and are in line with each other top to bottom and that the clips are marginally proud of the bath rim. [Please note If the bath does not have a timber frame such as on enamel baths) timber can be bonded to the underside using a suitable bonding agent] -
Using a tape measure carefully measure the bath to which the panel is to be filled. Place some masking tape at both ends of the bath panel and using a pencil carefully mark out the correct sizes required to suit the bath. Using a fine toothed saw, cut the panel to the required sizes. You may wish to clean the cut edges with a fine wet and dry paper.
(NOTE! before cutting check to ensure the sizes are correct)
-
Carefully fit the bath panel to the bath by gently pushing the bath panel into place.
Ensure that the bath panel is firmly held in place with the bath panel clips.
Please note to allow for future access the panel stops/clips are designed to hold the panel not lock it into position.
Additional timbers may be filled to the walls behind the panel and Velcro strips used to further secure the panel neatly and professionally.
Panel Fittings
Components shown below are supplied with the front panel (quantities dependant on panel type).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>