BN-LINK BNC-U3B1 24 Hour-Outdoor Mechanical Timer 6 Ways Garden Power Stake Instruction Manual
- June 5, 2024
- BN-LINK
Table of Contents
PRODUCT # BNC-U3B1
24 HOUR-OUTDOOR MECHANICAL TIMER 6 WAYS GARDEN POWER STAKE Please keep
this handbook
www.bn-link.com Designed in California,
Made in China
PRODUCTS VIEW
![BN LINK BNC U3B1 24 Hour Outdoor Mechanical Timer 6 Ways Garden Power Stake
-
fig](https://manuals.plus/wp-content/uploads/2022/06/BN-LINK-BNC-U3B1-24 -Hour-Outdoor-Mechanical-Timer-6-Ways-Garden-Power-Stake-fig.png)
- Slide Switch : Slide the switch down for timing. Slide the switch up for always ON.
- Arrow: Indicates the current time of day.
- Clock Dial : Black Part=6PM-6AM Hours; White Part=6AM-6PM Hours.
- Push Pins: Each pin represents 15 minutes. Pins down = ON; Pins up = OFF.
- Socket: 6x15R socket Only intended to be used with a grounded device.
RATINGS
Rated Voltage: 125V, 60Hz Max.Loading: 15A/1875W Resistive 15A/1875W Tungsten 1HP TV-5
WARNING
- Use a grounded outlet
- Follow local electrical codes
- For indoor/outdoor use
- Keep children away
- Unplug timer before cleaning
- Fully insert plug
- Do not use in wet locations
- Do not exceed electrical ratings
APPLICATIONS
- Lighting
- Heating systems
- Humidifiers
- Nebulizers
- Cooling systems
- Sprinklers
- Aquariums
- Ventilators
OPERATING INSTRUCTIONS
Step 1. Set a period of time for the unit to be “ON” Make sure all push pins are in the UP position before beginning. Locate the push pins and push them down at the marked times when the attached device is to be “ON”. Each pin represents a 15-minute time interval.
![BN LINK BNC U3B1 24 Hour Outdoor Mechanical Timer 6 Ways Garden Power Stake
- fig 1](https://manuals.plus/wp-content/uploads/2022/06/BN-LINK-BNC-U3B1-24
-Hour-Outdoor-Mechanical-Timer-6-Ways-Garden-Power-Stake-fig-1.png)
Example: “ON” time is 7:00 PM, “OFF” time is 9:30PM. Push down all of the
push pins between 7:00 PM and 9:30 PM. (Fig 1)
Note: Pushpins are slices around the dial.
Step 2. Set the “CURRENT TIME”
Rotate the entire push-pin dial clockwise until the arrow aligns with the current time of day on the dial.
Example: It is 6:00AM, please rotate the dial clockwise until the arrow aligns 6 AM on the dial. (Fig 2) Note: Please pay attention to AM/PM.
Step 3. Set “BYPASS SWITCH”
When the switch is up in ON position, the unit will bypass the programming and
your attached device will remain ON. When the switch is down in “0”position.
the unit will automatically turn your attached device ON and OFF according to
the programmed time. (Fig 3)
![BN LINK BNC U3B1 24 Hour Outdoor Mechanical Timer 6 Ways Garden Power Stake
- fig 3](https://manuals.plus/wp-content/uploads/2022/06/BN-LINK-BNC-U3B1-24
-Hour-Outdoor-Mechanical-Timer-6-Ways-Garden-Power-Stake-fig-3.png)
Step 4. Insert the plug of the timer into a wall socket
You may fix the timer on the wall with the two hang holes. (Fig 4)
Step 5. Attach appliances to any of the 6 outlet plugs available on the
front of the device
Please make sure the attached appliance is switched to the ON position before
plugging the appliance into the timer. (Fig 5)
HELPFUL TIPS
- This timer repeats the same settings daily.
- To push down or pull up the push pins, use your finger or the tip of a small instrument such as a pen or pencil.
- You can set up to 48 different “ON” and “OFF” times in a 24-hour period. Push pins pressed down represent the “ON” time, push pins in the up position represent the “OFF” time.
- When the switch is up in the ON position, the unit will bypass programming, however, the timer dial will continue to rotate and maintain the current time.
- Unit will stop operating if the power goes out. Once power is resumed, reset the time of day as explained in Step 2 of the instructions.
TROUBLESHOOTING
• PROBLEM: Appliances do not turn on as programmed.
o POSSIBLE CAUSE: Connected appliances are not in “ON” position; they are
not functioning; timer is not receiving power, or “BYPASS SWITCH” is up in ON
position. o CORRECTIVE ACTION: Ensure the connected appliances are
functional by plugging them directly into the outlet. Be sure the connected
appliances are in the “ON” position if they have their own switch. Make sure
the power outlet that the timer is plugged into is active. Check that the
“BYPASS SWITCH” is down in “ ” icon.
• PROBLEM: Appliances come on before or after programmed times. o
POSSIBLE CAUSE: “CURRENT TIME” was not properly set.
o CORRECTIVE ACTION: Check that the current time is correctly set. Note
that the black section includes hours from 6 pm to 6 am and the white section
includes hours from 6 am to 6 pm.
BN-LINK INC.
12991 Leffingwell Avenue, Santa Fe Springs
Customer Service Assistance: 1.909.592.1881
E-mail:support@bn-link.com
Http://[www.bn-link.com](http://www.bn-link.com)
Hours: 9AM – 5PM PST, Mon – Fri Designed in California Made in China
Documents / Resources
| BN-
LINK BNC-U3B1 24 Hour-Outdoor Mechanical Timer 6 Ways Garden Power
Stake
[pdf] Instruction Manual
BNC-U3B1 24 Hour-Outdoor Mechanical Timer 6 Ways Garden Power Stake, BNC-U3B1,
24 Hour-Outdoor Mechanical Timer 6 Ways Garden Power Stake
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>