plumbworld 8mm Black Wet Room Fixed Return Panel Installation Guide
- June 1, 2024
- plumbworld
Table of Contents
plumbworld 8mm Black Wet Room Fixed Return Panel
Product Guides
General Information
Please inspect this product upon delivery. Any missing parts or manufacturing defects must be reported immediately to the supplier. Damage or defects reported later will not be accepted. TAKE CARE WHEN HANDLING GLASS PARTS-AVOID HEAVY CONTACT BETWEEN THE GLASS EDGES AND ANY HARD SURFACE. Glass breakage claims will not be accepted after the product has been unpacked.
TOOLS REQUIRED
Warning
- This product is heavy and may require two people to install.
ASSEMBLY INSTRUCTIONS – DRAWING
A
- 1x Cover Cap (Wall Profile)
- 1x Wall Profile
- 1x Glass panel
- 1x Single Seal
- 5x Screws 4×30
- 5x Wall Plugs
- 1 x Wall Bracket
- 1x Top Bar
- 1x Screw Cap
- 1x Glass Clamp
- 4x Screws M5x5
- 1x T piece(Only for 700-900)
B
- 1x Corner Post Top Cap
- 1x Single Seals
- 1x Return Panel
- 1 x Bottom Seal
Before Installation
If installing wet room screens with a tray, Please ensure that the shower tray
is level and checked with a spirit level. The tray should be installed first.
Tiles should then be tiled down to the tray. The enclosure can then be
installed.
Step 1: DRILLING WALL PROFILE TO THE WALL
Step 2
Step 3
Step4
Step 5
Step 6
- Allow 24 hours for silicone to dry before use. Silicone on the outside edge only, NOT THE INSIDE.
Aftercare Instructions
- Regularly clean your shower product with warm soapy water to prevent lime scale build up.
- DO NOT use abrasive cleaning fluids or materials, or strong chemical cleaners as this will damage the product surface.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>