VON DUPRIN 78 Series Rim Device

Product Specifications

• Model Number: 47961351
• Product Name: 47961351 Rim Exit Device
• Device Type: 78 Rim Exit Device

Product Usage Instructions

Installation Instructions:

1. Draw horizontal device and strike center lines (CL).
2. Align strike on CL and mark the two slotted holes.
3. If necessary, prepare cutouts for cylinder or trim.
4. Prepare center case mounting holes.
5. Adjust tailpiece length if needed.
6. Prepare center case support holes.
7. If necessary, install cylinder.
8. If necessary, cut device.
9. Attach center case to door.
10. Mark and prepare two holes.
11. Install required support screws and center case cover.
12. Remove protective film from pushbar.
13. Adjust strike as needed.
14. Install end cap bracket and end cap.
15. Install strike support screw.

Frequently Asked Questions

• Q: What tools are needed for the installation of the 47961351 Rim Exit Device?
  • A: Special tools needed include #10-24, 1/4-20 tap Drill bits: #7, #25, 1/8, 1/4, 13/32, 1.
• Q: How can I lock down the pushbar on non-fire devices?
  • A: Use the Dogging Key provided with the device to lock down the pushbar.
• Q: Where can I find online information on the strikes shown in the instructions?
  • A: For online information on the strikes shown in the instructions, you can visit the web address provided: alle.co/99Rstrikes.

Installation Instruction

• 78 Rim Exit Device
• 78-F (Fire) Exit Device
• CD78 (Cylinder Dogging) Exit Device
• QEL78/-F (Electric Latch Retraction) Exit Deviceated

Special tools needed

• 10-24, 1/4″-20 tap

• Drill bits: #7, #25, 1/8″, 1/4″, 13/32″, 1″

Customer Service

• 1-877-671-7011
• www.allegion.com/us

SCREW CHART

Installation Instruction

1. Draw horizontal device and strike center lines

2. Align strike on and mark the two slotted holes.
   For online information on the strikes shown below, enter the web address shown.alle.co/99Rstrikes

3. Prepare 2 holes and install 2 screws
   See “Screw Chart” on previous page for screw types and sizes

4. Position template against strike and on and mark door.

5. If necessary, prepare cutouts for cylinder or trim.

6. Prepare 4 center case mounting holes.

7. Prepare 2 center case support holes

8. Adjust tailpiece length if needed
   Make sure tailpiece is installed at correct length for 1-3/4″ thick or 2-1/4″ thick door. If necessary, remove pine tree clip, rotate tailpiece, and reinstall pine tree clip.

9. If using a cylinder, remove cam and rotate 180º
   Cam must be in position shown with key removed. If necessary, remove cam screws, place cam is correct position, and reinstall cam screws.

10. If necessary, install cylinder

11. If necessary, cut device

12. Attach center case to door

13. Mark and prepare two (2) holes

14. Install end cap bracket and end cap

15. Install required support screws and center case cover

16. Adjust strike as needed

17. Install strike support screw.

499F STRIKE INSTALLATION

CD (CYLINDER DOGGING) OPTION

References

• Allegion
• Allegion US | Redefining Access Control & Commercial Security

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>