INMOTION WF20S 4 In 1 Magnetic Wireless Charging Station Instruction Manual

September 19, 2024
INMOTION

INMOTION WF20S 4 In 1 Magnetic Wireless Charging Station

Specifications

  • 4 in 1 Magnetic Wireless Charging Station
  • Wireless charging area with magnetic attraction
  • Folding Watch charging plate
  • Power indicator and button
  • Type C Input / Output
  • Charging pin for wireless earbuds
  • Charging indicator for status

Product Usage Instructions

Charging Station Setup

  1. Unfold the charging base and connect it to the mains using the provided USB-C cable.
  2. Place the power bank on the charging base and unfold the watch charging plate.
  3. Position your devices on the corresponding charging plates for charging.

Powerbank Recharge

  1. Ensure the charging base is connected to a power source.
  2. Place the power bank on the charging base to charge it.
  3. Alternatively, connect the provided USB-C cable to the power bank and a power source for charging.

FAQ

Important Safety Instructions
Please read and follow all safety information provided in the manual to prevent any accidents or damage. Here are key safety points:

  1. 1. Avoid high-temperature environments and exposure to fire.
  2. Handle the product with care to prevent damage from drops or impacts.
  3. Do not disassemble, repair, or modify the product.

OVERVIEW

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
Please read all safety information and operating instructions prior to using this battery product. Improper use of the product could result in excess heat, fire, explosion, electric shock, toxic fumes or other injury or damage.

  1. Do not place or store the product in any high-temperature environment, including intense sunlight or heat. Do not place the product in a fire.
  2. Be cautious of any excessive drops, bumps, abrasions, or other impacts to the product.
  3. Do not disassemble the product. Do not attempt to repair or modify the product in any manner. Do not try to replace any parts of the product.
  4. Do not expose the product to moisture or submerge it in a liquid. Keep the product battery dry at all times.
  5. Do not attempt to charge the product using any other method except as described in this manual. Only use the included cable to charge the product.
  6. The product is intended for use by adults. The product should only be used by minors when under proper adult-trained supervision. The product should never be used by small children.
  7. If you find that your product is not functioning properly, or if the product is emitting excessive heat, odor, deformed in any way, broken, cut, experiencing or demonstrating some abnormal phenomenon, stop using it immediately.
  8. When planning for extended storage of the product, first charge it for one hour.
  9. Do not use the product while in any potentially explosive atmosphere. Sparks in such areas could cause an explosion or fire, resulting in serious injury or even death.
  10. If you choose to dispose of the product, dispose of the battery in an appropriate manner following all federal and state regulations. Since the product contains electronic components and a battery, it cannot thrown away with normal household waste.

Charging Station

Unfold the charging base and connect it and the mains with the USB-C cable provided.

  • Put the power bank onto the charging base and unfold the watch charging plate.
  • Simply put your devices onto the corresponding charging plates to charge.

Powerbank Recharge

  • Make sure the charging base is connected to a power source. Put the power bank onto the charging to charge.
    Or, connect the provided USB-C cable to the power bank and the other end to a power source.

Wireless Charging

  • Align your iPhone (12 series or later) to the magnet ring of the power band and make sure they are attracted to each other.
  • Another wireless charging-supported device can also be charged wirelessly however they will not be attracted to each other.
  • To have a better charging performance, please remove the case of your device before charging.

Wired Charging

  • Insert a USB-C connector of a charging cable into the USB-C port of the power bank and connect the other end to your device.
  • The power bank supports wireless and wired charging simultaneously.

Battery Indicator

  • Press the power button to check the remaining battery capacity.
  • 4 lights on, indicating the remaining battery capacity is around 75-100%
  • 3 lights on, indicating the remaining battery capacity is around 50-75%
  • 2 lights on, indicating the remaining battery capacity is around 25-50%
  • 1 light on, indicating the remaining battery capacity is around 1 0-25% 1st light flashing, indicating the remaining battery capacity is under 1 0%. Power bank needs recharging.
    • Charging Station USB-C Input: DC 5V/3A, 9V/2A Powerbank USB-C Input: DC 5V/3A, 9V/2A
  • Output:
    • Powerbank USC-C: DC 5V/3A, 9V/2A, DC 12V/ 1.5A
  • Wireless: 5W, 7.5W, 10W, 15W (Phone)
  • Earphones: 5W
  • Watch: 2.5W
  • Powerbank Capacity: 10000mAh
  • Cable length: 1m (3.3 ft.)

FCC STATEMENT

FCC COMPLIANCE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance couldvoid the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna
  • Increase the separation between the equipment and receiver
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
  • Consult the dealer or an experienced radio / TV technician for help

ISED Canada Compliance
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. this device may not cause interference, and
  2. this device must accept any interference, including interference that may cause undesired operation of the device.

RF warning statement:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. iPhone is a trademark of Apple Inc., registered in the U.S. and other countries. InMotion and this product, are not affiliated with, or endorsed by Apple Inc. InMotion ™ is owned by InMotion Entertainment LLC. Colors and content may vary. Please retain this information for future reference.

contact

  • IMEG LLC, 3755 W Sunset Rd Suite A, Las Vegas, NV 89118 Produced in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals