INMOTION L9 PRO Electric Scooter User Manual

—Thank you for your reading!
L9 PRO+ Electric scooter

Product diagram

Specification

Folding

3 >put the hook  into the hook hole

Display

Operation steps

. Power button function description:

1. Power on/off:
   Press and hold the red power button on the right side to power the cooter on. Press and hold the button again to turn it off.

2. Gear switch:
   Gear switch: Tap the left red button to change gears. There are four gears: PO, P1, P2, and P3

3. Lighting:
   To turn the lights on or off, tap the power button quickly. Once for on, then again for off.

Safe Driving

1. Avoid accentuating the body while accelerating or decelerating and do not keep the bodyweight on the handle.
2. Riding a standing position, please keep the two feet one after the other, so that riding is more stable and easy to step on the rear brake.
3. Keep your body and handle parallel when turning. Please confirm the road condition before turning and keep safe.
4. Brake – When braking, please shift your bodyweight back. You’d better learn to control your body’s center of gravity when you brake. Otherwise, it will cause two situations: A Scooter forward, causing personal injury. B Braking and steering system damage

Strictly abide by local laws and regulations and traffic laws. Do not ride this scooter under the condition of low visibility. Do not use this car to do stunts, wheel, or take-off, it will increase the probability of injury and damage to the scooter. Do not carry passengers.  There is a risk of falling down and injury during the course of study. Please wear a helmet and protective gear throughout the study.

Charging precautions

When charging the electric scooter 19 Prot, please pay attention to the following points.

1. Ensure that it is charged in a dry and clean environment, the input voltage is guaranteed between 100v-240v and the other end connects the charging port of LS PRO-‘electric scooter. The red light indicates the scooter is being charged.
2. The indicator light of the charger shows the green light, indicating that the charging is completed.
3. Don’t turn on the scooter during charging for your safety.
4. Disconnect the scooter from the charger when the charging is complete.

There is a risk of falling down and injury during the course of study. Please wear a helmet and protective gear throughout the study.

Maintenance

1. Battery maintenance: In order to guarantee battery life, when the battery level is low, please charge the scooter timely
   (Note: When it is not in use for a long time, it is recommended that charge it once a month), If you want to check or replace the battery, please do it with the assistance of professionals. The most suitable temperature of the battery storage is 15 C -25 C; don’t use and place the scooter when the environmental temperature is higher than 40C, in order to avoid the lithium battery’s failure and even lead to combustion. Do not place the scooter in the car during the hot seasons, because it may lead to the lithium battery’s failure or even combustion.

2. Tire maintenance: In order to guarantee the tire life, please check the tires of the scooter regularly. Once the wheel is abnormal, please repair or replace timely, so as not to cause unnecessary damage during the riding.

3. Appearance maintenance: Swab the scooter body with water or mild detergent, it will make your scooter clean. Please do not clean the scooter with irritating potions or any chemical reagents.

Common Failures and Solutions

1)The display boa d is working but the motor doesn’t work

Reason analysis| Solutions
a.The brake handle is damaged| & Pull out the socket of the break handielnormalty open type brake handle). if the mota wood. then it is the theatre of break handle that should replace the brake handle.
b.The speed regulating steering handle is damaged| b.Firstly check the speed regulating steering handle and motors hall

switch are short circuits or not. gmerany it is easier to cause the joint short circuit Otter rain-affected with clamp, so neat that circuit of stealing handle and the motor hall swrickOtherwise there will be continuous damage of the replacement controller!

c.The motor is
damaged| cif the mace doesn’t turn, please inspect the motors’ hall switch and turning handles signaling the power-onAhe controller shell is very hotteneraUy it is a short circuit of the controller internal power tube. should immediately cut off the power.
2)Charging doesn’t work
Reason analysis| Solutions
a.The battery charging port is loose| a.Change a good charging port
b.The connection of the charger plug is bot well| a– Change a good changer connector. ‘
3)Ca n’ t turn on the scooter
Reason analysis| Solutions
a.The battery is dead| a.charges the scooter for 1-2 hours according to the user manual
b.The power button is out of order| b.heck the power button which has got stuck or not.

L9 PRO+ Electric scooter

Please read the user manual and get to know the performance of the L9 PRO+ intelligent electric scooter before using the product. Don’t lend the scooter to the people who can’t handle it.

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

IC Caution:

This device complies with Industry Canada s licence-exempt RSS. Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

conditions exposition portables sans restriction.

Documents / Resources

| INMOTION L9 PRO Electric Scooter [pdf] User Manual
ZSF9, 2AZ3Z-ZSF9, 2AZ3ZZSF9, L9, PRO Electric Scooter
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>