DONGGUAN AIBA001 Sand Art Bluetooth Lamp Instruction Manual
- September 17, 2024
- Dongguan
Table of Contents
DONGGUAN AIBA001 Sand Art Bluetooth Lamp
Packaging accessories
Power Supply×1、operating instructions×1。
Product introduction
【Environment and Function】
Recommended to use in a quiet environment, such as bedroom, study, living room, office, etc. Noisy environment will affect the product experience.Please power up the product (hereinafter referred to as: me) and use it.
★The optimal distance for the user to say the command word is up to 2 meters, beyond that distance please raise your voice.Please add an accent to the noun
Instructions for use
Wake-up words
When you turn on the power, please say the wake-up word “Hello smart light / Hey smart light”, and I will reply “I am here” to indicate that I have been woken up (entered the wake-up state). If I don’t receive any voice commands within 30 seconds after waking up, I will go into hibernation state, if you need to use it, you need to wake me up again.
★Tip: You can’t do any command operation in hibernation state.
LED Functions
To voice contrl the LED lights：
Blutooth Speaker Functions
Voice control to open the bluetooth, Device name: BT-BOX
Troubleshooting
misidentification
Confirm whether it wakes up; whether the speech rate is too fast or too slow; whether the voice-activated distance is too far; whether the environment is noisy;
【Solution】
Try Couple times
Invalid command
No voice response or response error
【Solution】
Reboot; the distance position between the human voice and the product is
within 2 meters, and there is no obstruction between them;
check if the product has this command function.
False wake-up/ recognition
Sounds similar to arousal words and command words appear in the environment.
Non working
Please check the power supply.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>