Dongguan Jintop Power JP-01-21005A Wireless Power Charger User Manual
- October 27, 2023
- Dongguan Jintop Power
Table of Contents
JP-01-21005A Wireless Power Charger
DONGGUAN JINTOP POWER CO., LTD
Mode: JP-01-21005A
INSTALLATION INSTRUCTIONS
Electrical rating: Input: DC 5V/2.1A form Adapter; output :5W Wireless
CAUTION: Modifications which are not approved by the party responsible
for compliance could void user’s authority to operate the equipment
WARNING: To reduce the risk of fire, electric shock, or injury to persons:
- Use the unit for indoor only.
- Do not use extension cord(s) to connect the unit.
- Do not try to open the unit for any reason.
- The power line should be replaced by manufacturer, service orginization or qualified staff, please do not connection personally
INSTALL:
- The power adapter should be used under DC 100V-240V.please check the Voltage before use it!
- Please use it in the secure environment, do not cut the cord .
- For indoor use only.
- picture and drawing:
FCC WARGING:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation
is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>