PawHut D51-153 Rolling Small Animal Cage with 4 Platforms Instruction Manual
- September 16, 2024
- PawHut
Table of Contents
PawHut D51-153 Rolling Small Animal Cage with 4 Platforms
PARTS
HARDWARE
NOTE: Do not tighten bolts fully until all parts are connected!
INSTALLATION
Note: The cage is upside down for this step.
- A x 1
- B x 1
- C x 2
- M x 4
- N x 1
Tracks facing in
Connect the Bottom Back Wire (A) and the Bottom Front Wire (B) to the Side
Wire (C) with the tracks facing up and towards the inside of the cage.
Tip: Do not fully tighten bolts until all panels are in place.
- I x 2
- J x 2
- M x 4
- N x1
Insert the Casters into the Bottom Front (A) and Back (B) Wires, then connect
both by screwing in bolts on each side(see inset image). Place the locking
casters in the holes at the cage front. Flip the cage so the wheels are on the
ground.
Tip: the tabs on the support bars should be facing towards the outside.
- D x 1
- E x 1
- M x 4
- N x 1
Add the Top Back Wire (D) and Top Front Wire (E) to the lower portion of the
cage by inserting each panel into the slots provided. Then screw in the top
bolts into the Lower Side Panels to connect the upper and lower wires.
Note: Make sure that the panels with the doors are placed on the same
side.
Connect the Side Wires (C) to the Top Back and Front Wires using 4 bolts for each Side Panel.
Lower the Top Wire into place and attach with bolts on each corner. Tighten all bolts used in previous steps.
Slide the Plastic Pull Pan into the slots located on the lower panels.
Connect the ramps to the bottom of the shelves as shown in the image. Place assembled shelves and ramps in the cage through the doors. Next, attach the top shelf with a Short Ramp to the 14th bar up from the center bar at the back of the cage. Then, attach the middle shelf with a Short Ramp to the 3rd wire down from the center bar in the front.
DONE
CONTACT INFORMATION
If you have any questions, please contact our customer care center. Our contact details are below:
- 001-877-644-9366
- customerservice@aosom.com
- Imported by Aosom LLC
- 27150 SW Kinsman Rd Wilsonville, OR 97070 USA
- MADE IN CHINA
- 0044-800-240-4004
- enquiries@mhstar.co.uk
IMPORTER ADDRESS:
- MH STAR UK LTD
- Unit 27, Perivale Park,
- Horsenden lane South
- Perivale, UB6 7RH
- MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>