YSI 626972 Pro Solo ODO Optical Dissolved Oxygen Meter User Guide

September 14, 2024
YSI

YSI 626972 Pro Solo ODO Optical Dissolved Oxygen Meter

Specifications

  • Item Number: 626972
  • Micro USB port for charging and data transfer
  • Battery indicator for monitoring power level
  • Military spec, twist-lock cable connector for durability

Product Usage Instructions

Setting Up:

  1. Charge the battery by connecting the handheld to an AC power supply or USB connector using the micro USB cable. Ensure all components are dry when charging. A full charge takes approximately 9 hours.
  2. Make sure the date/time is correct and set the logging mode (Single or Continuous).
  3. Setup sensor parameters and select units displayed on the Run and Data View screens.
  4. Calibrate sensors prior to taking measurements; sensor-specific calibration instructions can be found in the User Manual.

Taking Measurements:
Insert the probe into the sample and briefly move it up and down to release any air bubbles. Allow measurements to stabilize and press the Enter key to log data. To stop Continuous logging, simply press the Enter key again.

Data Management:

  • Press the File key to view, delete, or backup logged data. Data can be filtered by date/time and by the user-created Site and/or Data ID.
  • Transfer data to your PC using KorDSS Software. Make sure the instrument driver and software are installed from the included USB flash drive or from YSI.com.
  1. Open KorDSS Software.
  2. Use the micro USB cable to connect the handheld to the PC.
  3. Power on the handheld; there may be a short delay before it shows up in the software.
  4. Select the handheld under the Instrument Connection Panel and click Connect.
  5. Click Start Download from Device.
  6. After data download, click View Logged Data to view, print, and export data files from KorDSS.

FEATURES

This is a reference guide for operating the ProDIGITAL line of handhelds. Refer to the User Manual for more information.

1725 Brannum Lane Yellow Springs, OH 45387 800-765-4974, 937-767-7241 info@ysi.com

YSI.com/ProDSS-Training

Item# 626972 Dwg# 626972 December 2019 Rev E

FAQ

Q: How long does it take to fully charge the battery?
A: A full charge takes approximately 9 hours. Ensure all components are dry when charging.

Q: How can I calibrate sensors?
A: Press the Cal key to calibrate the attached sensors. Refer to the User Manual for sensor-specific calibration instructions.

Q: How do I stop Continuous logging?
A: Simply press the Enter key again to stop Continuous logging.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals