OPTONICA 19031 Pendant Lamp Holder User Manual
- September 14, 2024
- OPTONICA
Table of Contents
19031 Pendant Lamp Holder
“`html
Product Information
Specifications
- SKU: 19031-19073
- Manufacturer: Prima Group 2004 LTD
- Country of Origin: Bulgaria
- Electrical Requirements: Standard electrical network
Product Usage Instructions
Installation
-
Align the pendant lamp holder with the wall plugs.
-
Drill the installation points and insert the wall plugs into
the ceiling. -
Secure the holder with screws.
-
Connect the wires to the electrical network.
-
Install the cover, aligning it with the pendant lamp holder,
and secure it with screws.
Notes
-
Before installation, turn off the electrical network.
-
Never cut the lamp cables to adjust the length, as this will
void the warranty. -
Follow national standards and installation instructions in the
manual for manufacturer’s responsibility. -
For cleaning, disconnect the power and use a soft cloth with
products having a neutral pH.
Safety Instructions
Caution: Do not cut the power cable or steel
cable. Follow safety requirements and periodically test electrical
installations by a qualified electrician.
Contact Information
Importer: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1,
bl. 144, Ground Floor; Phone: +359 2 988 45 72;
FAQ
Q: Can I adjust the height of the steel cables?
A: Yes, you can adjust the steel cables by pressing the pin, but
remember to release the pin after adjusting to the ideal
height.
“`
USER MANUAL
SKU: 19031-19073 PLEASE COMPLY WITH ALL TECHNICAL SPECIFICATIONS INDICATED ON THE PACKAGING.
IMPORTANT
These instructions must be read carefully before installation and use. This document is part of the product and must be safely kept by the user.
PRODUCT INSTALLATION
1. Align the pendant lamp holder with the wall plugs. 2. Drill the installation points and insert the wall plugs into the ceiling. 3. Secure the holder with screws. 4. Connect the wires to the electrical network. 5. Install the cover, aligning it with the pendant lamp holder, and secure it with screws.
NOTE:
1. Before installation, turn off the electrical network. 2. Never cut the
lamp cables to adjust the length, as this will void the warranty. 3. The
manufacturer’s responsibility is guaranteed only if the applicable national
standards, as well as the installation instructions contained in this manual,
are followed. 4. For cleaning, we recommend disconnecting the power. Always
clean with a soft cloth and products with a neutral pH, without alcohol and
solvents.
The icon is illustrative
CAUTION
PROHIBITED
PRESS THE PIN TO ADJUST THE STEEL CABLES TO THE IDEAL HEIGHT.
– Cutting the power cable is prohibited – Cutting the steel cable is
prohibited
GENERAL SAFETY REQUIREMENTS
RELEASE THE PIN AFTER ADJUSTING THE STEEL CABLES TO THE IDEAL HEIGHT.
The electrical installation must be tested periodically by a qualified electrician at least once every 10 years. For offices and commercial premises, the wiring should be inspected at least once every 5 years.
IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1, bl. 144, Ground Floor; Phone: +359 2 988 45 72;
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>