ZHONG JUN TOYS FACTORY F01A-1 Remote control Car User Manual
- June 12, 2024
- ZHONG JUN TOYS FACTORY
Table of Contents
ZHONG JUN TOYS FACTORY F01A-1 Remote control Car
Product Information
- Frequency: 2.4G
- Battery parameters:
- Remote control: 2 x 1.5V AA
- Car: 3.7V Li-ion
- Type: F01A
- FCC ID: 2AZFNF01A-1
- Manufacturer Address: ZHONG JUN TOYS FACTORY, CHENGHAI DISTRICT, SHANTOU CITY, GUANGDONG PROVINCE, CHINA
Product Usage Instructions
Car:
- Remove the battery compartment cover.
- Place one grain of 3.7V Li-ion battery in the correct position when using.
- Replace the battery compartment cover.
Remote Control:
- Remove the screw.
- Remove the battery compartment cover.
- Place two grains of 1.5V AA battery in the correct position when using.
- Replace the battery compartment cover and screw.
FCC Statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Important Announcement:
Radiation Exposure Statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
How to Play?
How to Replace Battery?
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>