Teltonika FMM640 4G LTE Cat M1 Tracker With Tachograph and CAN Data
- September 13, 2024
- teltonika
Table of Contents
Teltonika FMM640 4G LTE Cat M1 Tracker With Tachograph and CAN Data
Description
FMM640 has 100 configurable Geofence zones and it can generate an event when a defined Geofence zone border is crossed. Frame border is an additional border around the Geofence zone used to prevent false events when an object stops on the border of the area and as a result, records are made inside and outside the defined area because of GNSS errors. The event is generated only when both (Geofence and frame) borders are crossed. See the figure to the right for details: the blue track is considered to have entered the area while the red track is not.
The shape can be a rectangle or a circle as defined by the user. Priority of Geofence event is categorized into Low, High, or Panic levels. These levels define the priority of event information that is sent to the server. For more details about priorities look in the I/O settings section.
Geofence settings
Generate event allows you to choose when the record will be generated. Eventual records control where scenario status value appears: when disabled it will exist in each AVL record and when enabled the value will be appended only to eventual records. OverSpeeding helps to configure OverSpeeding scenarios separately for each different Geozone. Regular OverSpeeding and geo zones OverSpeeding function independently.
If digital output control is enabled in a regular OverSpeeding scenario, geo zones OverSpeeding scenario will control it too i.e when the device is in more than one zone and OverSpeeding is detected in any zone then the digital output turns on. Digital output turns off only when OverSpeeding is not detected anywhere. X1 is used to set the geofence zone left bottom corner X coordinate (longitude) while Y1 is used to set the Y coordinate (latitude).
OverSpeeding scenario
X2 or R are used to set accordingly the geofence zone upper right corner X coordinate (longitude) when the Rectangular zone is used or circle radius when the Circular zone is used. Y2 sets the geofence zone upper right corner Y coordinate (latitude) for a Rectangular zone.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>