GRACO GIM-0046K Baby Delight Instructions

GRACO GIM-0046K Baby Delight

Product Information

Specifications

• Model : GIM-0046K
• Languages : EN, IT, DE, NL, SV, FI, NO, DA, PL, HU, RU, SK, CZ, EL, AR, HR, SR, SL

Product Usage Instructions

1. Assembly
   Follow the step-by-step assembly instructions provided in the manual to set up the Baby Delight product correctly.

2. Operation
   Once assembled, ensure all components are securely in place before using the product. Refer to the manual for operational guidelines.

3. Maintenance
   Regularly check and clean the product as per the maintenance instructions provided. Ensure all parts are in good condition for safe use.

WARNING:
Complies to EN16232:2013+A2:2023

PARTS

WARNING:
IMPORTANT – Keep these instructions for future reference
Failure to follow these warnings and the assembly instructions could result in serious injury or death.

• Always use the restraint system.
• Never leave the child unattended.
• Do not use this product once your child can sit up unaided or weighs more than 9kg.
• Never use this product on an elevated surface (e.g, a table, etc).
• Do not move or lift this product with the baby inside it.
• Do not let children play with this product.
• To avoid injury ensure that children are kept away when unfolding and folding this product.
• Always use on a flat, level floor.
• Never let the child sleep in this product. This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.
• Do not use the product once the child can sit unaided,
• Do not use the product without the seat cushion
• Do not leave or place the product close to another product that could present a danger of suffocation or strangulation, e.g. strings, blind/curtain cords, etc. Strings can cause strangulation.
• DO NOT place items with a string around your child’s neck, such as hood strings or pacifier cords, etc.
• DO NOT suspend strings over the product or attach strings to the toys
• DISCONTINUE USING YOUR PRODUCT should it become damaged or broken. Swing intended for children up to 9kg;
• Do not use the product if any parts are broken, torn, or missing, and use only spare parts approved by the manufacturer. Do not use accessories other than those approved by the manufacturer.
• Be aware of the risk of an open fire and other sources of strong heat, such as electric bar fires, gas fires, etc. in the vicinity of the product.
• This product requires adult assembly. Follow assembly instructions carefully. If you experience any difficulties, please contact the Customer Service Department.
• Transformer or batteries: The product is not to be connected to more than the recommended number of power supplies.
• Children should be supervised to ensure that they do not play with the appliance.
• Electronic toys (on certain models): Do not open, No serviceable parts inside. Remove and immediately dis- card plastic tab from the slot in the toy.

FOR SAFE BATTERY USE

• Keep the batteries out of children’s reach.
• Batteries are to be inserted with the correct polarity.
• Only the recommended batteries or equivalent are to be used, volts, and size.
• Remove exhausted batteries from the product.
• DO NOT short-circuit supply terminals.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Any battery may leak battery acid if mixed with a different battery type if inserted incorrectly (put in backward), or if all batteries are not replaced or recharged at the same time. Do not mix old and new battenes.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Any battery may leak battery acid or explode if disposed of in fire or an attempt is made to charge a battery not intended to be recharged.
• Never recharge a cell of one type in a recharger made for a cell of another type.
• Non-rechargeable batteries are not to be recharged.
• Discard leaky battenes immediately. Leaky battenes can cause skin bums or another personal injuries. When discarding batteries, be sure to dispose of them properly, according to the state and local regulations.
• Always remove batteries if the product is not going to be used for a month or more. Batteries left in the uni may leak and cause damage.
• Recommended type batteries – alkaline disposables.
• NEVER mix battery types. Change batteries when the product ceases to operate satisfactorily.
• The crossed-out wheelie bin symbol indicates the product is to be recycled.

CARE AND MAINTENANCE

• FROM TIME TO TIME CHECK YOUR PRODUCT for loose screws, worn parts, tom material, or stitching. Replace or repair the parts as needed. Use only Graco replacement parts.
• REMOVABLE CLOTH SEAT COVER may be machine washed in cold water on a delicate cycle and drip-dried.
• NO BLEACH.
• TO CLEAN FRAME, use only household soap and warm water.
• NO BLEACH or detergent.
• Excessive exposure to sun or heat could cause fading or warping of parts.

PROBLEM-SOLVING

The product won’t operate:

1. No batteries in the swing.
2. Batteries dead.
3. The speed setting is too low.
4. Batteries in backward – check „+” and -“.
5. Corrosion on battery terminals. Rotate batteries in place against terminals, or clean with sandpaper or steel wool if corrosion is severe.
6. Baby leaning far too forward
7. Baby grabbing swing legs. (Discontinue use).
8. The seat was not pushed high enough for a good start.
9. Protective device activated. (Turn off the motor, wait 3 minutes, then restart the swing).

The seat doesn’t swing very high:

1. Control setting too low.
2. Blankets hanging down, causing increased wind resistance.
3. Batteries are too weak.
4. Baby leaning too far forward,
5. Baby is too heavy or too active. (Discontinue use).
6. Soft carpet (swing higher on hard floors).

Assembly

Assembling Product

• Make sure the straps on the mesh sides are not twisted. Snap seat back into smaller hole on mesh sides.

• Snap seat bottom into large hole on mesh sides.

• Check to make sure seat bottom and seat back are securely snapped into mesh sides by pulling on the base of mesh sides.

• See image

• See image

• See image

• Insert plastic tab into bottom slot on the side of the seat back. Attach tab to hook on back of seat. Repeat on the other side. Attaching Legs

• See image

• wing the legs outward until the single button snaps into its notch. CHECK that the legs are properly attached by twisting them in the housings. Rear Tube

• See image

• CHECK that legs are properly attached by twisting them in the housing.
  Front Tube

• CHECK that legs are properly attached by twisting them in the housing.

• See image
  Attaching Seat to Frame

• Snap the swing seat into brackets as shown. Pull down on the wing arms to make sure it is securely snapped into handles.

• Attach the elastic loop on the mesh sides, to the plastic hook on the bottom of the handle. Repeat on the other side of the swing.

• See  image

• Secure Child

• See images (17-21)

• Use the slide adjuster at the shoulder and waist for further adjustment. Repeat on the other side.

• When changing harness strap slots, MAKE SURE harness straps are going through the same slots in seat pad and seat back.

• The harness straps must go into the slot that is even with or slightly above the shoulders. Avoid twisting straps. To Adjust Recline

• See images

• Press in both recline latches on back of seat to lower.

• To raise, push seat back up to desired position.
  Installing Batteries

• With the baby out of swing, open the battery compartment lid by inserting a key into the slot. Insert four “C”-LRI4 (I.SV) cell batteries. Replace battery lid. CHECK that the batteries are put in comectly.  Your swing will not run if the batteries are put in backward. Refer to the wamings section for safe battery use. Starting Product
  WARNING : avoid serious injury from falling or sliding out. Always use a harness. After fastening the buckles, adjust the belts to get a snug fit around your child. Observe the swinging motion for a minute. It takes time for the product to adjust to a setting, Change the setting if needed.

  • A small, quiet baby will swing higher on each setting than a larger, more active baby.
  • Your seat may be stopped at any time the motor is running without damaging the motor.
  • Push the product to restart. If your product motor stops operating by itself, a protective device may have been activated, Tum off the motor, wait three minutes, and then restart the swing.
    On/Off

• See images 08 – 29
  Storage

• See images 30 – 8D Toy bar

• See images 82 – 83

• Check to make sure the toy bar is secure by pulling on it.

FAQ

Q: How do I clean the Baby Delight product?
A: Use a damp cloth with mild soap to wipe down the product. Avoid using harsh chemicals that may damage the materials.

Q: Can I disassemble the product for storage?
A: Yes, you can disassemble the product following the reverse steps of the assembly instructions for convenient storage.

References

• Graco Baby EU: Car Seats, Strollers, & Gear For Your Child | Graco Baby

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>