ASCENDO WOEND GWE A30L Passive On Wall Mount Speaker Instruction Manual
- September 7, 2024
- ASCENDO
Table of Contents
ASCENDO WOEND GWE A30L Passive On Wall Mount Speaker
IMPORTANT SAFETY INSTRUCTIONS
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- Clean only with a dry cloth.
- Install this apparatus according to the manufacturer’s instructions.
- Do not install this apparatus near any heat sources such as radiators, heat registers, stoves, or other apparatus.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, or the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
DISPOSAL
Correct disposal of this product (Waste Electrical & Electronic Equipment) This symbol means the product must not be discarded as household waste and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling help protect natural resources, human health, and the environment. For more information on the disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.
RoHS
This product is RoHS compliant. This product complies with Directive
2011/65/EU, and its amendments, on the restriction of the use of certain
hazardous substances in electrical and electronic equipment.
REACH
REACH (Regulation No 1907/2006) addresses the production and use of chemical
substances and their potential impacts on human health and the environment.
Article 33(1) of the REACH Regulation requires suppliers to inform the
recipients if an article contains more than 0.1 % (per weight per article) of
any substance(s) on the Substances of Very High Concern (SVHC) Candidate List
(‘REACH candidate list’). At the time of the release of this product, no
substances on the REACH candidate list are contained in a concentration of
more than 0.1% per weight in this product.
THANK YOU FOR CHOOSING ASCENDO IMMERSIVE AUDIO.
For more than 25 Years, ASCENDO has been involved in music reproduction. We
are confident that the AlA product you have chosen will provide every note of
enjoyment that you expect. Please take a moment to register your product on
our website at
www.aia-cinema.com. This enables us to keep you
posted on our latest advancements and helps us to better understand our
customers and build products that meet their needs and expectations. All
features and specifications are subject to change without notice.
PACKAGE CONTENTS
SPEAKER PLACEMENT
Positioning your loudspeakers properly is critical to achieve the sonic performance of a home theater. Please read the following section for guidance on correct and optimal placement.
LEFT, RIGHT and CENTER speakers
The THE5 PASSIVE ON WALL is a perfect choice to serve as powerful front left
right and center main speakers in a multi-channel system. Since they have been
designed for uniform coverage and maximum dispersion of sound, they should be
placed with the center of the speaker driver at about the same height on
screen as the actors to aid in the illusion that the actors’ voices are coming
directly from their on-screen images. Ideally, the speakers will be placed
about 60 degrees apart from each other viewed from the listening position, so
that the distance between the speakers is the same as each speaker’s distance.
The recommended mounting of the THE5 PASSIVE ON WALL is horizontal or vertical
because the speakers possess an axis-periodic dispersion pattern.
If a non-perforated projection screen, or LCD/plasma/OLED display is being
used in the installation, the THE5 PASSIVE ON WALL may be used in horizontal
orientation mounted directly below or above and as close as possible to the
video display.
NOTE: In such an installation scenario it is extremely important to place the
center, left, and right speakers as close as possible to the same height. The
center of the speaker driver in the center channel speaker should be no more
than 2 feet (61cm) higher or lower than those in the left and right speakers.
This preserves the localization integrity of “sound pans” in which the sound
appears to move from left to center to right. If the program material also
appears to travel up and down, it can destroy the illusion of lifelike panning
effects. To mitigate the height difference between the center speaker the Left
and Right channel speakers should be lowered or elevated slightly depending on
if the center is installed below or above the screen.
Using the speakers as surround speakers
Surround speakers should be placed on or in the side walls no closer to the
screen than the first row of viewing chairs. If there are two rows of chairs,
these speakers should be placed between the two rows. Surround speakers should
be placed higher than the seating area. The rule of thumb is that the center
of the speaker cone should have direct access to each ear with all seats
occupied so that no occlusion of the direct line of sight happens between the
tweeter and each ear.
Using the speakers as rear surround speakers.
Rear Surround speakers should be placed on or in the rear walls. Rear Surround
speakers should be placed higher than the seating area. The rule of thumb is
that the center of the speaker cone should have direct access to each ear with
all seats occupied. This is especially challenging with seats possessing high
back supports. Ideally, no occlusion of the direct line of sight happens
between the tweeter and each ear.
Listening distance and volume variation.
Ideally, the minimum listening distance is 2 meters or 12 feet to a surround
speaker. The minimum and the maximum listening distance variation should be as
low as possible, i.e. minimum 2 meters, maximum 4 meters, which reduces the
listening volume difference to 6dB in the worst case.
Possible speaker positions
CONNECTIONS
Speakers and electronics have corresponding (+) and (–) terminals. Most manufacturers of speakers and electronics, use red to denote the (+) terminal and black for the (–) terminal. It is important to connect both terminals identically: (+) on the speaker to (+) on the amplifier, and (–) on the speaker to (–) on the amplifier. This connection ensures, that all speakers work in unison and make a forward movement if a positive signal is applied and move backward when a negative signal is applied. It is important to connect all speakers identically: (+) on the speaker to (+) on the amplifier and (–) on the speaker to (–) on the amplifier. Wiring any one speaker “out of phase” (+ to – and – to +) to other speakers in the system results in thin sound, weak bass, and poor imaging. With the advent of multichannel surround sound systems, connecting all the speakers in your system with the correct polarity remains equally important to preserve the proper ambiance and directionality of the program material.THE5 PASSIVE ON WALL uses both (+) (+) and (-) (-) for its connection, please see the image for possible connecting options. Both (+) (+) and (-) (-) are internally connected. The (+) terminal of the dedicated amplifier channel must be connected to the (+) terminal(s) of the speaker as the (-) terminals of the amp need to be connected to the (-) terminal(s) of the speaker.In this wiring configuration, the amplifier will be presented with a nominal 8 Ohms speaker load.THE5 PASSIVE ON WALL is specifically designed for use in conjunction with low-noise amplifiers where the residual noise floor of the amplifier should be below 40µV.Connect your main receiver or processor’s output to the line-level input on your amplifier.
CONNECTING THE SPEAKERS TO AMPLIFICATION
To connect THE5 PASSIVE ON WALL loudspeakers to a power amplifier(s) or
receiver, use a two-conductor insulated speaker wire.
- Wire length recommended size.
- Up to 40 ft. (12m) 14-gauge
- Up to 60 ft. (20m) 12-gauge
- THE5 PASSIVE ON WALL push-on Phoenix connectors can accommodate up to #12 AWG stranded wire.
CARING FOR YOUR PRODUCT
Wipe the cabinet with a clean, dry cloth to remove dust. A damp cloth may dull the cabinet’s finish. Do not use volatile liquids such as benzene, paint thinner or alcohol on the cabinet. Do not spray insecticide near the cabinet.To remove dust from the grille fabric, use a vacuum cleaner, soft brush, and set to low suction. Do not wash the grille in water, as water may fade the grille’s color or make it uneven.If the surface of the woofer cone becomes dusty you can carefully sweep it clean with a soft, dry calligraphy brush or paint brush or low air pressure. Do not use a damp cloth.
SPECIFICATIONS
The THE5 PASSIVE ON WALLl is supplied with a front cover as standard Technical modifications subject to change without further notice
DIMENSIONS
THE5 PASSIVE ON WALL
DOCUMENTS RESOURCES
- ASCENDO_THE5 PASSIVE ON WALL (pdf)
ASCENDO Immersive Audio GmbH Adlerstrasse 2, Gebäude C, EG D-91560 Heilsbronn • Germany Tel.: +49 9872 9 537 157 • www.aia-cinema.com