Disney 97161 Minnie Mouse RC Car User Manual

Disney 97161 Minnie Mouse RC Car

INTRODUCTION

The Disney 97161 Minnie Mouse RC Car is a fun remote-controlled car that is sure to excite young Minnie Mouse enthusiasts. This adorable remote-control vehicle, produced by Jada Toys, has a traditional Minnie Mouse style that is both elegant and fun. Children three years old and older may easily maneuver their automobile around the house or outside thanks to its simple remote control and single frequency channel of 27 MHz. This miniature car is the ideal size for small hands to handle, measuring just 7 x 4 x 5 inches and weighing only 0.96 ounces. Two AAA batteries are needed for the RC car, which means hours of nonstop enjoyment. The Minnie Mouse RC Car is a great birthday present or a fun addition to any child’s toy collection. It keeps kids entertained for hours on end and helps them develop their hand-eye coordination. With this entertaining toy, you can bring the wonder of Disney home!

SPECIFICATIONS

PRODUCT INSTRUCTIONS

Keep these instructions for future reference

they contain important information.

IMPORTANT: Please read all “Consumer Information” before operating your vehicle.

ADULT SUPERVISION REQUIRED Surfaces may become hot and cause burns if electronics get wet. Do not operate the vehicle through water or snow.

Consumer Information:

Note to Adults: To ensure that the child’s play is both safe and fun, please review all operating instructions and safety rules with your child.

CONTENTS: Vehicle x 1, Transmitter Controller x 1

Safety Tips:

• NEVER drive your vehicle on the streets! They’re for real cars!
• DO NOT pick up the vehicle while in motion.
• Avoid collisions with walls or hard surfaces.
• Keep fingers, hair, and loose clothing away from the tires and the wheel hubs while the vehicle is switched ON.
• Adult supervision is recommended when this vehicle is being operated.
• To avoid accidental operation, remove all batteries when not in use.
• Be sure to rest your vehicle for at least 5 minutes after every 15 minutes of operation.
• Please avoid unintended play with electric wire (soft antenna), as it may damage the product or result in strangulation.

PRODUCT OVERVIEW

BOTTOM OF VEHICLE To install batteries, remove the battery cover (Use a screwdriver to remove the screw Not Included) and unclip. Insert new batteries as shown.

BOTTOM OF TRANSMITTER CONTROLLER

REMOTE CONTROL

BATTERY INSTALLATION

BEFORE BATTERY INSTALLATION

• Your new R/C is designed to work with standard 3 “AA” alkaline batteries, sold separately.
• The controller is designed to work with standard 2 “AAA” alkaline batteries, sold separately.

Installing Batteries in the R/C (Diagram 1)

1. Push the ON/OFF to the “OFF” position on the vehicle.
2. Remove the battery cover (Use a screwdriver to remove the screw – Not Included) and unclip.
3. Remove the used batteries (if any).
4. Insert the 3 “AA” alkaline batteries, with polarity (+/-) as shown inside the battery compartment.
5. Snap the battery compartment door back into place and replace the screw.

Installing Batteries in the Transmitter Controller (Diagram 2)

1. Remove the battery cover (Use a screwdriver to remove the screw – Not Included) and unclip.
2. Remove the used batteries (if any).
3. Insert 2 “AAA” alkaline batteries, with polarity (+/-) as shown inside the battery compartment.
4. Snap the battery compartment door back into place and replace the screw.

Battery Safety Information

• Ensure that battery polarity is correct.
• Use only batteries of the type recommended (or equivalent).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Remove used-up batteries immediately. Remove batteries if the vehicle will not be used for a long period to prevent possible leakage.
• Do not recharge non-rechargeable batteries.
• Do not short-circuit terminals.
• Dispose of batteries safely. Do not dispose of batteries (or products containing non-replaceable batteries) in a fire, as batteries may explode or leak.

QUICK TIPS

• When your vehicle starts to lose power, it may lose functions or performance. It’s time for fresh batteries (or a recharge). Your vehicle’s running time may change depending on your driving style.
• Radio interference can make your vehicle run badly. Interference can be caused by other R/C vehicles running on the same frequency, electrical wires, large buildings, or CB radios. Try to stay away from these!
• Point your transmitter controller antenna up—not down toward your vehicle. If your vehicle gets too far away, it won’t work properly.
• Don’t drive your vehicle in sand or through water or snow.
• Don’t store your vehicle near heat or in direct sunlight. Always turn switches OFF and remove all batteries for storage.
• If the vehicle resets automatically, the batteries are weak and need to be changed.

Cleaning Instructions

• To clean, wipe excess dirt from the toy.
• Remove batteries first.
• Wipe the toy clean with a wet cloth using plain water.
• Wipe dry.
• DO NOT IMMERSE IN WATER and DO NOT CLEAN THE VEHICLE WITH ANY CHEMICALS.
• Let the toy completely dry before putting the batteries back into a clean, dry battery compartment.

TROUBLESHOOTING

installed with incorrect polarities. Check the + and – markings to make sure the batteries are properly aligned. 3. Batteries are drained. Charge batteries and/or install new batteries.
The car does not respond to controls| 1. The transmitter controller battery is drained. Replace 2 (two) “AAA” alkaline batteries on the controller. 2. The vehicle is out of range. Bring the controller closer to the vehicle. 3. Interference from surrounding electrical machinery. Bring it to a wide open space.
The car does not move| Release the trigger immediately, and rest your car for a few minutes.

Industry Canada Warning

Operation is subject to the following two conditions:

1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

This Category III radiocommunication device complies with Industry Canada Standard RSS-310.

COMPLIANCE WITH FCC REGULATIONS (VALID IN THE U.S. ONLY)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

This device generates and uses radio frequency energy and, if not used properly, may cause interference to radio and television reception. It has been tested and found to comply with the limits set by the FCC which are designed to provide reasonable protection against such interference.

FCC Warning

CAUTION: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Warranty Information

Jada Toys, Inc. warrants to the original consumer purchaser that the product will be free of defects in material and workmanship for thirty (30) days from the date of purchase. Jada Toys will repair or replace the product, at their sole option, in the event of such a defect within the warranty period.

In the event of a defect covered under this warranty, first call the toll-free number listed below. Many problems can be solved this way. If necessary, you will be instructed to return the product (postage prepaid and insured by the consumer) to the address below. Enclose your name, address, telephone number, a copy of the dated sales receipt, and a brief explanation of the defect. Repair or replacement, and return shipment, will be free of charge.

CONTACT INFORMATION

• Address for Returns: Consumer Relations, Jada Toys, Inc. 938 Hatcher Ave. City of Industry, CA 91748, USA
• Toll-Free Number: 1-800-679-JADA (5232) (Valid only in U.S.A. and Canada)
• Hours: 9:00 A.M. – 5:00 P.M. Pacific Time, Monday – Friday.

FREQUENTLY ASKED QUESTIONS

What is the Disney 97161 Minnie Mouse RC Car?

The Disney 97161 Minnie Mouse RC Car is a remote-controlled car designed for young children, featuring a Minnie Mouse theme. It is manufactured by Jada Toys and offers a fun and engaging way for kids to enjoy RC car play.

What are the dimensions of the Disney 97161 Minnie Mouse RC Car?

The car measures 7 x 4 x 5 inches, making it a compact and easy-to-handle toy for young children.

How much does the Disney 97161 Minnie Mouse RC Car weigh?

The car weighs approximately 0.96 ounces, which is lightweight and suitable for young children to manage.

What frequency does the Disney 97161 Minnie Mouse RC Car operate on?

The RC car operates on a single frequency channel of 27 MHz.

What is the recommended age for the Disney 97161 Minnie Mouse RC Car?

The car is recommended for children aged 3 years and up, making it an ideal toy for toddlers and young kids.

What type of batteries does the Disney 97161 Minnie Mouse RC Car require?

The car requires 2 AAA batteries to operate. These batteries are not included with the toy and need to be purchased separately.

Who is the manufacturer of the Disney 97161 Minnie Mouse RC Car?

The Disney 97161 Minnie Mouse RC Car is manufactured by Jada Toys, a company known for producing high-quality toy vehicles.

What is the price of the Disney 97161 Minnie Mouse RC Car?

The car is priced at $19.89, making it an affordable option for a themed RC car.

Does the Disney 97161 Minnie Mouse RC Car have any special features?

The car features a cute Minnie Mouse design and is designed to be simple to operate, making it ideal for young children.

How does the Disney 97161 Minnie Mouse RC Car compare to other RC cars in its price range?

Compared to other RC cars in its price range, the Disney 97161 Minnie Mouse RC Car stands out for its Disney branding and age-appropriate design.

Why won’t the Disney 97161 Minnie Mouse RC Car turn on?

Ensure the batteries in both the car and remote are fully charged or new. The Disney 97161 Minnie Mouse RC Car requires AA batteries for both the car and controller. Double-check the battery orientation as per the instructions.

Why is the Disney 97161 Minnie Mouse RC Car not responding to the remote control?

Verify that both the car and the remote are switched on. Make sure there is no signal interference nearby. Try pairing the remote and car again by turning them off and on. Also, ensure the remote control is within the effective range of the Disney 97161 Minnie Mouse RC Car.

Why does the Disney 97161 Minnie Mouse RC Car move slowly?

The Disney 97161 Minnie Mouse RC Car may be running low on battery power. Replace or recharge the batteries, ensuring they are the recommended type (AA). Additionally, check for any obstructions in the wheels or gears.

How do I fix the Disney 97161 Minnie Mouse RC Car if it only moves in one direction?

The issue could be related to the control stick or button on the remote. Ensure the remote control is functioning properly and not stuck. If the problem persists, inspect the internal wiring of the Disney 97161 Minnie Mouse RC Car to see if a motor or gear needs repair.

What should I do if the steering on the Disney 97161 Minnie Mouse RC Car is unresponsive?

Check the alignment of the front wheels and see if anything is blocking their movement. If the problem persists, check the remote’s steering control functionality. Loose or damaged internal components of the Disney 97161 Minnie Mouse RC Car might also be the cause.

VIDEO – PRODUCT OVERVIEW

DOWNLOAD THE PDF LINK:Disney 97161 Minnie Mouse RC Car User Manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>