renkforce 2583518 FDM 3D Printer Pro 6+ User Guide
- June 3, 2024
- renkforce
Table of Contents
renkforce 2583518 FDM 3D Printer Pro 6+
Read the safety instructions supplied with the product before using
Set printer up
-
Insert the print bed and magnetic mat.
-
Remove the Styrofoam pads
-
Install the spool holder.
-
Slide the filament spool onto the holder.
-
Insert the filament tube in the feeder.
-
Insert the filament tube into the extruder.
-
Connect the mains cable to the power inlet on the printer.
-
Flip the power switch into the position I to switch on. The display lights up.
Calibrate Z-Offset
-
Insert the print bed and magnetic mat.
-
Open the menu Tools.
-
Touch the button Preheating to start the pre-heating process.
-
Wait until the preheat temperature has been reached.
-
Open the menu Manual.
-
Touch to move the extruder to its zero position.
-
Activate the Z-offset calibration with the slider.
-
Touch the distance increment 0.1 mm to activate it.
-
Slide one sheet of A4 paper (80 g) between the nozzle and the print bed.
-
Slide the paper back and forth while repeatedly touching the button or to lift or lower the print bed. If you notice slight resistance between nozzle, paper, and print bed, touch the button to finish the calibration.
-
Confirm the Z-offset calibration.
-
Touch the button Leveling to start “Auto-levelling”.
-
Wait for “Auto-levelling” to finish.
Load filament
-
Open the menu Tools.
-
Open the menu Filament.
-
Touch the temperature display to preheat the extruder.
-
Cut the filament at an angle and then feed it into the feeder.
-
Touch the button E1 Load to load the filament into the extruder.
-
Touch the button Stop as soon as molten filament flows from the nozzle.
CAUTION
Hot print bed
Touching hot print bed can cause burns Let cool down before touching
-
Connect the USB memory stick that contains the print file to the USB port.
-
Open the menu Print.
-
Select file to print. The printer starts printing.
-
After printing is complete, let the printer cool down to room temperature.
-
Remove the magnetic mat.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirsch au (www.conrad.com). All rights including
translation reserved. Reproduction by any method, e.g. photocopy,
microfilming, or the capture in electronic data processing systems require the
prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2022 by Conrad Electronic SE.
*2583518_V1_0822_02_mq_jhen(2)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>