GERMAN POOL MIF-255 Electric Milk Frother Induction Heating User Manual

Electric Milk Frother (Induction Heating)
MIF-255 USER MANUAL

MIF-255 Electric Milk Frother Induction Heating

Please read these instructions and warranty information carefully before use and keep them handy for future reference.

Online Warranty Registrationhttp://www.germanpool.com/warranty

Please register your warranty information now!
For Warranty Terms & Conditions, please refer to the last page of this user manual.

Notice Before Use

Important
For safety purpose, please observe the following safety precautions to avoid injury or property damage. Failure to follow the safety warning may result in an accident.
This device is only intended for use in households in enclosed spaces for:
– making milk foam and heating milk.
– melting of little chocolate pieces during heating of milk.
Uses for a different purpose or for a purpose which exceeds this description are considered incompatible with the intended or designated use.

Warning!
Dangers can emanate from the device if it is used for an unintended use and/or a different kind of use.
– Use the device exclusively for its intended use.
– Observe the procedural methods described in this User Manual.
Claims of all kinds due to damages resulting from unintended uses are excluded. The User bears the sole risk.

Note!
– Examine the device for any visible external damages prior to using it. Never put a damaged device into operation.
– If the connection lead is damaged, a new connection lead installed by an authorized electrician is needed.
– This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
– Children shall not play with the appliance.
– Cleaning and maintenance shall not be made by children without supervision.
– Keep the appliance and its cord out of reach of children less than 8 years.
– Do not leave the device unsupervised when it is in operation.
– Only qualified electricians, who have been trained by the manufacturer, may carry out any repairs that needed.
Improperly performed repairs can cause considerable dangers for the user.
– Only customer service departments authorized by the manufacturer may carry out repairs on the device during the guarantee period, as otherwise the guarantee entitlements will be null and void in the event of any subsequent damages.
– Defective components must always be replaced with original replacement parts. Only such parts will guarantee that the safety requirements are fulfilled.
– See more details about cleaning in “cleaning and maintenance”.

Danger!
The heated milk in the milk frother and the jug can get very hot. Observe the following safety instructions and be careful not to burn or scald yourself or others:
– When the milk is heated, the jug gets very hot!
– Always check the temperature of the milk before drink.
– When you are heating the milk, keep the lid closed.
– The surface of heating element can be hot after use, be careful.

Mortal danger exists when coming into contact with live wires or subassemblies! Observe the following safety notices to avoid dangers due to electrical power:
– If the connection lead is damaged, a special connection lead installed by an authorized electrician is needed.
– Packaging materials may not be used for playing. There is a danger of suffocation.
– Do not operate this device if its power cable or plug is damaged, if it does not work properly or if it is damaged or has been dropped. If the power cable is damaged, it must be replaced by the manufacturer or service agency or a similar qualified technician, to avoid any dangers.
– Do not open the housing on the device under any circumstances. There is a danger of an electrical shock if live connections are touched and the electrical or mechanical structure is altered. In addition, functional faults on the device can also occur.
– Never immerse the device, cord or plug in water or other liquids and do not place in the dishwasher.

All the technical information, data and notices with regard to the installation, operation and care are completely up-todate at the time of printing and are compiled to the best of our knowledge and belief, taking our past experience and findings into consideration. No claims can be derived from the information provided, the illustrations or descriptions in this manual. The manufacturer does not assume any liability for damages arising as a result of the following:

• Non-observance of the manual
• Uses for non-intended purposes
• Use of unauthorized spare parts
• Improper repairs
• Technical alterations, modifications of the device

Product Structure

MAX MILK
MAX FROTH MIN

The appliance has got three markings for the filling:

Operating Instructions

Note:
– Examine the shipment for its completeness and for any visible damages.
– Immediately notify the carrier and the supplier about any incomplete shipment or damages as a result of inadequate packaging or due to transportation.

PREPARATION

1. Unpack the Milk Frother, remove all the packaging materials.

2. Clean the appliance thoroughly before the first use. (See chapter Care and maintenance)

3. Setup the appliance in a right location:
   • The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing capacity.
   • Choose the setup location in such a way that children cannot reach the device.
   • The device is not intended to be installed in a wall or a built-in cupboard.
   • Do not set up the device in a hot, wet or extremely damp environment or near flammable material.
   • The electrical socket must be easily accessible so that the power lead can be disconnected easily, in the case of an emergency.
   • The installation and assembly of this device in non-stationary setup locations (e.g. on ships) must be carried out by specialist companies / electricians, provided they guarantee the prerequisites for the safe use of this device.

4. Electrical connection:
   • Before connecting the device, compare the connection data (voltage and frequency) on the rating plate with those of your electrical network. This data must agree in order that no damages occur in the device. If in doubt, ask your qualified electrician.
   • The electrical outlet must be protected by a 16A safety cut-out switch.
   • The connection between the device and the electrical network may employ a 3 meter long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs is prohibited because of the danger of fire that is involved with this.
   • Make sure that the power cable is undamaged and has not been installed under the device or over hot or sharp surfaces.
   • The electrical safety of the device is only guaranteed if the device is connected to a properly installed protective conductor system. Operations using an electrical outlet without a protective conductor are prohibited. If in doubt, have the house installation checked over by a qualified electrician.

The manufacturer cannot be made responsible for damages that are caused by a missing or damaged protective conductor.

OPERATION
Note:
Do not leave the device unsupervised when it is in operation, so that you can intervene quickly in the event of dangers.

Operation Video Tutorialhttp://www.germanpool.com/chi/video_corner/?video=468

COLD MILK FROTH (Room Temperature)
Maximum capacity for cold milk froth (Room Temperature): 150 ml

1. Put the whisk into the whisk holder. Do not use the basket for melting.
2. Fill milk and press the button  and the button lights up in white.
3. The appliance starts to make milk froth and stops automatically as soon as the process is finished. A signal tone will be heard and then you can remove and pour out the milk forth.

Note:
– Make sure the Milk Frother is filled to at least the MIN mark and not exceed the MAX FROTH marking. Otherwise the milk will overflow.
– To stop the operation, just press the button again.

WARM MILK FROTH
Maximum capacity for warm milk froth: 150 ml

1. Put the whisk into the whisk holder. Do not use the basket for melting.
2. Fill milk and press the button and the button lights up in white.
3. The appliance starts to make milk froth and stops automatically as soon as the process is finished. A signal tone will be heard and then you can remove and pour out the milk forth.

Note:
– Make sure the Milk Frother is filled to at least the MIN mark and not exceed the MAX FROTH marking. Otherwise the milk will overflow.
– To stop the operation, just press the button again.

HOT MILK
Maximum capacity for hot milk: 250 ml

1. Put the whisk into the whisk holder with the basket for melting.
2. Fill milk and press the button twice and the button lights up in blue.
3. The appliance starts to heat milk (67±5°C) and stops automatically as soon as the process is finished. A signal tone will be heard and then you can remove and pour out the milk.

Note:
– Make sure the Milk Frother is filled to at least the MIN mark and not exceed the MAX MILK marking. Otherwise
the milk will overflow.
– To stop the operation, just press the button again.

INSTANT HOT BEVERAGES
Maximum capacity for hot beverages: 250 ml

1. Put the whisk into the whisk holder with the basket for melting.
2. Add maximal 0.15 g cocoa or 37.5 g chocolate in little pieces, or instant beverage powders with milk or water. Press the button and the button lights up in red.
3. The appliance starts to heat and mix (77±5°C) and stops automatically as soon as the process is finished. A signal tone will be heard and then you can remove and pour out the hot beverages.

Note:
– Make sure the Milk Frother is filled to at least the MIN mark and not exceed the MAX MILK marking. Otherwise the milk will overflow.
– To stop the operation, just press the button again.

SETTINGS

Note:
– Ensure the lid is fully closed before switching on. Do not open the lid when milk is heating, scalding may occur if the lid is lifted.
– Do not touch any moving parts whilst in use. Always switch off the appliance and wait until the whisk has stopped rotating before you open the lid.
– Please pour out the milk and the milk froth.

Care & Maintenance

NOTE:
Please observe the safety instructions, before cleaning your device:
– Before cleaning switch off the unit and take the power plug out of the outlet.
– Clean the unit with a soft cloth.
– Don’t clean the device with inflammable detergents.
– Clean the device again thoroughly when the machine hasn’t been used for a long time.
– Cleaning and user maintenance shall not be made by children without supervision.

Cleaning Video Tutorialhttp://www.germanpool.com/chi/video_corner/?video=469

1. Take off the lid with the whisk. You can remove the magnetic whisk from the side from its holder.
2. Clean the lid and the whisk, the basket as well as the jug of the milk frother with diluted detergent, with warm water and a soft sponge or a cloth.
3. Clean the lid and the whisk with lukewarm water, the jug can be washed in the dishwasher. The base is not suitable for dishwasher. Do not immerse base in water or other liquids.

Troubleshooting

If the following problems are encountered, follow the instructions below. If the problem persists, please contact our customer service and repair centre.

the mains plug is connected correctly.
Electronic defect.| Please contact customer service.

Note:
– Repairs of electrical appliances must be carried out by the manufacturer, by an authorized repair centre or by other qualified technicians.
– Repairs performed by untrained persons may result in considerable hazards for the user and damage the machine.
– If above mentioned steps don’t solve the problem, please contact our customer service and repair centre.

Technical Specifications

Specifications are subject to change without prior notice.
If there is any inconsistency or ambiguity between the English version and the Chinese version, the Chinese version shall prevail.
Refer to www.germanpool.com for the most up-to- date version of the user manual.

German Pool (Hong Kong) Limited

Hong Kong, China
Room 113. Newport Centre Phase II. 116 Ma Tau
Kok Road. Tokwawan. Kowloon. Hong Kong.
Tel: +852 2773 2888
Fax:+852 2765 8215| Mainland China
3/F, Takshun Plaza, Nanguo East Road,
Shunde, Foshan, Guangdong
Tel:+86 757 2980 8308
Fax:+86 757 2980 8318| Macau, China
3/F, Edificio Industrial Pou Fung,
145 Rua de Francisco Xavier Pereira, Macau
Tel:+853 2875 2699
Fax:+853 2875 2661
---|---|---

© All rights reserved. Copying, reproducing or using the contents of this manual is not allowed without prior authorization from German Pool, violators will be prosecuted.

www.germanpool.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>