nordlux ETHAN 2 Spot Built On Lighting Instruction Manual
- August 28, 2024
- nordlux
Table of Contents
nordlux ETHAN 2 Spot Built On Lighting
Product Specifications:
- Class : II
- Isolation : Double
- Grounding Requirement : Not required
DIMENSION
Product Usage Instructions
Installation:
- Check that the lamp is Class II and double insulated.
- As per safety standards, this lamp does not need to be connected to the ground wire during installation.
- Follow the manufacturer’s instructions for mounting and securing the lamp in place.
Usage:
- Ensure the lamp is placed on a stable surface or securely mounted on a suitable fixture.
- Use the appropriate wattage and type of light bulb recommended for the lamp.
- Avoid touching the lamp when it is turned on as it may become hot during operation.
IP20 : The lamp should only be installed in areas where direct contact with water cannot occur.
Class II: The lamp is double-insulated and does not need to be connected to the yellow/green earth wire.
Disposal of waste equipment by users in private households in the European Union. This symbol indicates that this product must not be disposed of with your other household waste. Electrical and electronic equipment contain substances that may cause damage to human health and the environment if not recycled correctly. It is your responsibility to hand over to a designated collection point for recycling of waste electrical and electronic equipment. When handing over for correct recycling you help to prevent these products from straining nature and the environment unnecessarily and to protect human health. For more information regarding correct disposal, please contact your local city office, your household waste disposal service or the store where you purchased this product.
The lamp is only suitable for connecting directly to the mains.
The mounting instruction must not be discarded.
MAX 2x50W: Do not exceed the maximum wattage.
IMPORTANT! Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
Nordlux A/S – Ostre Havnegade 34 • DK-9000 Aalborg
FAQ
Q: Do I need to ground this lamp during installation?
A: No, the lamp is Class II and double-insulated, so it does not require
grounding.
Q: Can I use any type of light bulb with this lamp?
A: It is recommended to use the appropriate wattage and type of light bulb as
specified by the manufacturer for safe operation.