Bushnell POWERVIEW 2 binoculars Owner’s Manual
- June 5, 2024
- Bushnell
Table of Contents
POWERVIEW 2 binoculars
Owner’s Manual
Thank you for purchasing your new Bushnell® PowerView® 2 binoculars.
This manual will help you optimize your viewing experience by explaining how
to adjust the binoculars to your eyes, and how to care for this instrument.
Read the instructions carefully before using your binoculars.
DANGER: NEVER LOOK DIRECTLY AT THE SUN WITH YOUR BINOCULARS, AS IT MAY
CAUSE SERIOUS DAMAGE TO YOUR EYES
PARTS GUIDE
A. Ocular Lens
B. Center Focus Knob
C. Eyecups
D. Tripod Adapter Socket*
E. Objective Lens
F. Diopter Adjustment Ring**
- under socket cap (compact models are not tripoded adaptable)
** no diopter ring on the compact models-rotate entire right eyecup
EYECUP ADJUSTMENT
Your Bushnell PowerView 2 binoculars are fitted with eyecups that provide a
comfortable view of the entire image and help to exclude extraneous light. If
you need to wear glasses when using binoculars, leave the eyecup in the “down”
position (or, for models with fold-down style eyecups, fold them down) (Fig.
1, next page). For use without eyeglasses or sunglasses, twist up the
eyecups (or, for models with fold-down style eyecups, simply leave them up)
(Fig. 2). This will place your eyes farther from the binocular ocular
lenses, at the correct eye relief distance, allowing you to see the entire
field of view.
IPD (INTERPUPILLARY DISTANCE) ADJUSTMENT
The spacing between the pupils of your eyes, called “interpupillary distance,”
varies from person to person. To match your binoculars to your IPD or “eye to
eye” width:
- Point them at a white wall or blank area of the sky. Hold the binoculars and view them as you normally would. Don’t worry about focus yet.
- Grasp each side of the binocular firmly. Move the left and right sides closer together or farther apart (Fig. 3, next page) until you see a single image with no shaded areas.
FOCUS AND DIOPTER ADJUSTMENT
- Adjust the eyecups and IPD as described in the previous sections.
- Using the attached lens cap or your hand, cover the objective lens on the right side of the binocular.
- Using the center focus knob, focus on a distant object with fine detail (e.g., brick wall, tree branches, etc) until it appears as sharp as possible when viewed through the left side of the binocular.
- Uncover the objective lens on the right side, and cover the left objective lens while continuing to view the same object.
- Rotate the diopter adjustment ring (NOT the center focus knob) located directly below the right eyecup (Fig. 4) to bring the object into focus on the right side of the binocular. Note: on the compact 10x and 16x models, there is no ring; rotate the entire right eyecup to adjust the diopter. Avoid over-turning or forcing the diopter mechanism. If you are unable to bring the object into focus for your right eye by adjusting the diopter ring/eyecup, make sure the left side is still in focus (repeat steps #2-4 if necessary). The diopter adjustment essentially provides “fine focus” on one side of the binocular (right only) to allow for slight differences in the vision of your left and right eyes.
- Your binoculars should now be adjusted for your eyes. Focusing for any distance can now be done simply by turning the center focus knob. Make a note of your diopter setting (position of plus and minus marks on diopter ring relative to index mark on binocular below the ring) for future reference in case the ring is moved accidentally or by another person using your binocular.
NECKSTRAP ATTACHMENT
To attach the neckstrap, thread the ends of the neckstrap through the strap
lug (Fig. 5) on each side of the binocular, then back through the plastic
buckle on the strap (Fig. 6). Adjust the position of the binoculars on
your chest as they hang around your neck to your preference, by changing the
length of the strap section which passes through the strap channel, and buckle
by an equal amount on each side. If you prefer to use an aftermarket strap
that has metal O-rings, attach them to a plastic zip tie placed on the strap
lugs rather than installing them directly on the lug, to avoid damaging the
finish on the binocular via contact with the rings. TRIPOD MOUNTING (compact
models are not tripoded adaptable)
To attach the binocular to a tripod or monopod, unscrew (10×42 model) or pull
off (10×50, 12×50, 20×50 models) the cap which covers the threaded (1/4-20UNC)
socket at the far end of the center hinge (Fig. 7), and set it aside in a safe
place. Use a compatible binocular tripod adapter accessory (90º angle
bracket), such as the Bushnell #161002CM, to attach your full-size PowerView 2
binocular on any standard tripod in a horizontal position, to provide a stable
image during prolonged viewing, or when using high power models such as the
20×50. MULTI-COATED OPTICS
All models have lenses with multiple, microthin layers of anti-reflective
coating. This provides increased light transmission for a brighter, clearer
image. It’s important to take proper care of your binoculars to avoid damage
to these lens coatings that could be caused by improper cleaning methods.
CLEANING
- First, blow or brush away any dust or debris on the lens (using “canned air” or a soft lens brush).
- To remove dirt or fingerprints, clean with the supplied soft storage bag (made of washable microfiber cloth), rubbing in a circular motion. Use of a coarse cloth (including paper towels) or unnecessary rubbing may scratch the lens surface and eventually cause permanent damage. The included storage bag/micro-fiber cloth is ideal for the routine cleaning of your optics. Simply breathe lightly on the lens to provide a slight amount of moisture, then gently rub the lens with the microfiber cloth.
- For a more thorough cleaning, photographic lens tissue and photographic lens cleaning fluid or isopropyl alcohol may be used. Always apply the fluid to the cleaning cloth – never directly on the lens.
- To prevent potential damage to the optical coatings on the binocular lens surfaces, never use household window cleaning liquids. Avoid using facial tissue or clothing that may have fibers that can be abrasive and hold oils or dirt.
CARE OF THE OPTICS
- Your Bushnell PowerView 2 binoculars will provide years of trouble-free service if it receives the normal care you would give any fine optical instrument.
- Avoid sharp impacts. Set the binocular down gently on hard surfaces.
- Tug on the strap after attaching, making sure it is securely fastened to the binocular before placing it around your neck.
- Store your binoculars in a cool, dry place whenever possible.
Technical Specifications
SKU| ChassisSize| Magnification| ObjectiveDiameter|
PrismSystem| Field ofvie w ft#1000yds / m1000m|
ExitPupil(mm)| Eye Relief(mm)| C lose Focus (ft/m)| Length
(in/mm)| Weight (oz/g)
---|---|---|---|---|---|---|---|---|---|---
PWV1025| Compact| 10x| 25 MM| Roof| 300 / 100| 2.| 10| 15 / 4.6| 4.5/115| 9.2
/ 260
PWV1632| Compact| 16x| 32 MM| Roof| 180 / 60| 2.| 12| 18 /5.5| 5.5/140| 10.9/
310
PWV1042| Full| 10x| 42 MM| Roof| 288 / 96| 3.| 15| 20 / 6.1| 5.9/150| 22.2 /
630
PWV1050| Full| 10x| 50 MM| Porro| 344 / 115| 5.0| 16| 25 / 7.6| 6.5/165| 27.8
/ 790
PWV1250| Full| 12x| 50 MM| Porro| 265 /88| 4.0| 10| 24 / 7.3| 6.7/170| 28.4 /
805
PWV2050| Full| 20x| 50 MM| Porro| 165 / 55| 3.| 105| 31 / 9.4| 6.7/170| 28.4 /
805
PWV821| Compact| 8x| 21 MM| Folding Roof| 378 / 115| 3.| 10| 21 / 6.4| 3/7/95|
7.2 / 205
PWV842| Compact| 8x| 42 MM| Roof| 290 / 88| 4.| 16| 25 / 7.6| 5.9/150| 23 /
652
Products manufactured on or after April 2017 are covered by the Bushnell
Ironclad Warranty. The Ironclad Warranty is a full lifetime warranty that
covers the lifetime of this Product. Each Product has a defined lifetime;
lifetimes can range from 1 to 30 years. This Product’s lifetime can be found
at the website listed below and/or on the Bushnell webpage specific to this
Product.
We warrant that this product is free from defects in materials and workmanship
and will meet all represented performance standards for the lifetime of this
Product. If this product isn’t working properly due to a covered defect, we
will, at our option, either repair or replace it and ship it back to you at no
charge. This warranty is fully transferable and does not require a receipt,
warranty card, or product registration. This warranty does not cover the
following: electronic components; batteries; cosmetic damage; damage caused by
failing to properly maintain the product; loss; theft; damage as a result of
unauthorized repair, modification, or disassembly; intentional damage, misuse,
or abuse; and ordinary wear and tear. This Warranty will be void if the date
stamp or other serialization codes have been removed from the Product.
To view the full warranty and find details on how to request service under the
warranty, go to our website at
www.bushnell.com/warranty. Alternatively,
you can request a copy of the warranty by calling us at
1-800-423-3537 or writing to us at
one of the following addresses:
IN U.S.A. Send To:
Bushnell Holdings, Inc.
Attn.: Repairs
9200 Cody
Overland Park, Kansas 66214
IN CANADA Send To:
Bushnell Holdings, Inc.
Attn.: Repairs
140 Great Gulf Drive, Unit B
Vaughan, Ontario L4K 5W1
For products purchased outside the United States or Canada please contact your
local dealer for applicable warranty information.
This warranty gives you specific legal rights.
You may have other rights which vary from country to country.
©2020 Bushnell Outdoor Products
Bushnell,™, ®, denote trademarks of Bushnell Outdoor Products
www.bushnell.com
9200 Cody, Overland Park, KS 66214
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>