YHTAUTO FFFOOE002S Factory Style Fender Flares Instruction Manual

YHTAUTO FFFOOE002S Factory Style Fender Flares

Before Installation

• Compatibility: It is important to verify that each flares fit your vehicle. If necessary, some fling, sanding, or cutting may be needed to ensure fitting properly.
• Painting(optional): Before putting flares on the vehicle, flare-painting could be applied if it’s desired. Use a good grade degrease to clean flares’ surface, and then paint the flares.
• Metal protection: Before adding flares, paint a rust-resistant coating to protect all exposed fasteners and bare metal. After the flare installation, the inner fender wells should be sprayed with undercoating.
• Decals removal: Flares may obstruct your existing vehicle decals. Remove decals before installing flares if you want.

Tools Required

(Not Included in the Product)

• 7mm, 10mm Sockets
• Ratchet
• Plastic Pry Tool
• Panel Removal Tool
• Exterior Detailer
• Microfiber Cloth

Component List

Front Flare Installation Procedures

• Step 1:
  Before disassembly, place all front fender flares in the sun to encourage manipulation during installation.

• Step 2:
  Remove the (4) plastic push clips and (2) 7mm bolts from the inner fender. Keep clips and bolts for reinstallation.

• Step 3:
  Firmly pull the OEM fender flare from the vehicle.
  NOTE: The clips may require slight prying to dislodge from the fender, gently use a plastic pry tool.

• Step 4:
  Clean the vehicle flare area using an exterior detailer and a microfiber cloth.

• Step 5:
  Remove all rubber caps from the pre-installed mounting clips on the new fender flare.

• Step 6:
  Fit the fender flare to the vehicle fender, and ensure all clips are secure in the fender.

• Step 7:
  Secure the inside of the flare by using the OEM plastic push clips and 7mm bolts.

• Step 8:
  Complete front fender flare installation.
  Rear Flare Installation Procedures

• Step 9:
  Before disassembly, place all rear fenders flares in the sun to encourage manipulation during installation.

• Step 10 :
  Remove the (4) plastic push clips and (2) 10mm bolts from the inner fender. Keep clips and bolts for reinstallation.

• Step 11 :
  Firmly pull the OEM fender flare from the vehicle.
  NOTE: The clips may require slight prying to dislodge from the fender, gently use a plastic pry tool.

• Step 12 :
  Clean the vehicle flare area using an exterior detailer and a microfiber cloth.

• Step 13:
  Remove all rubber caps from the pre-installed mounting clips on the new fender flare.

• Step 14:
  Fit the fender flare to the vehicle fender, and ensure all clips are secure in the fender.

• Step 15:
  Secure the inside of the flare by using the OEM plastic push clips and 10mm bolts.

• Step 16:
  Installation is now completed.

Attention

• Please use the appropriate shop manual for the installation instructions.
• If you do not have enough skills to install this part,it is recommended to seek help from a qualified mechanic.

Fit for Ford F-150 2009-2014 OE Factory
Style, a set of 4pcs

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>