PetSafe 2 Gallon Pet Fountain Owner’s Manual
- August 28, 2024
- PetSafe
Table of Contents
PetSafe 2 Gallon Pet Fountain
Product Information
Specifications:
- Product: Pet Fountain
- Usage: Indoor
- Cleaning Frequency: Pump and fountain every 2-4 weeks, carbon filter every 4 weeks, foam filter every 2 months
- Water Level Requirement: Pump designed to work in at least one inch of water
Product Usage Instructions
Care Instructions:
To ensure fresh, clean water for your pet, follow these tasks:
- Refill often.
- Keep the water level above one inch to prevent pump failure.
- Clean the pump and fountain every 2-4 weeks with soap and water, avoiding soap in filters.
- Replace the carbon filter every 4 weeks and the foam filter every 2 months.
Setup Instructions:
- Refer to the schematic diagram for pump installation.
- Install the pump according to the directions provided.
- Place the cord in the designated notch.
- Install the filter unit by soaking it in clean water and rinsing it slightly.
- Install the lid and flower in sequence, connecting the power adaptor.
Product Usage:
- Ensure the pump is cleaned every 2 weeks for product longevity.
- To clean the pump:
- Remove the Pump Cover.
- Remove the Impeller cap by placing the fingernail underneath the small lip.
- Clean the Impeller and parts with soap and warm water.
- Place the fountain where your pet can access it.
- Fill with water, leaving a half-inch space between the water and the rim.
- Ensure hands, cord, and power adaptor are dry.
Keep health and happiness flowing!
Cautions:
- Always shut down and disconnect the power supply when not in use for safety.
- Use indoors only.
- Avoid flooding the power adapter and wire plug during cleaning.
- Do not run the product without water (unless it has an automatic outage function).
- Disconnect the power supply before maintenance and cleaning.
FAQ:
-
Q: How often should I replace the filters?
A: Replace the carbon filter every four weeks when cleaning the fountain, and replace the foam filter every two months for optimal performance. -
Q: Can I use this product outdoors?
A: No, this product is designed for indoor use only to ensure proper functioning and safety.
Pet Fountain
Before we start: Care instructions
To keep providing fresh, clean water for your pet, remember these three simple
tasks:
-
Refill often
Keep the water level up. The pump is designed to work in at least one inch of water. The pump can fail if it runs dry. -
Clean your pump and your fountain
Take your pump and fountain apart to clean with soap and water every two to four weeks. Be careful not to get soap in the filters, as it will not rinse out. -
Replace your filters
- Replace the carbon filter every four weeks when you clean your fountain.
- Replace the foam filter every two months.
What you have
Setup instructions
- Schematic diagram for pump instillation
- Install the filter:
- Install the lid & flower
Use instructions
Place the fountain where your pet will use it. Fill the vessel with water, leaving a half inch of space between the water and the rim. Make sure your hands, the cord, and the power adaptor are dry.
Keep health and happiness flowing!
Cleaning
To extend product life, please clean the pump every 2 weeks.
- Remove the Pump Cover
- Remove the Impeller cap by placing your fingernail underneath the small lip.
- Remove the Impeller and clean the parts with soap and warm water.
Cautions
- Be sure to shut down and disconnect the power supply for safety when the equipment is not in use.
- This product is for indoor use only.
- The power adapter and wire plug must not be flooded during cleaning.
- This product is not allowed to run without water (can be ignored for models with the function of outage automatically without water).
- Please disconnect the power supply before maintaining and cleaning the machine.