HOMEMATE HM-ZJ-04B Remote Control Outlet Instruction Manual

HOMEMATE HM-ZJ-04B Remote Control Outlet

Product Usage Instructions

Setup

1. Plug the remote base into a grounded 3-prong outlet.
2. Plug your electrical device into the remote base. Ensure the device is powered ON.
3. Use the button on the remote control to turn your device ON and OFF.

Battery Information and Replacement

The remote control uses a 3-volt CR2032 lithium battery.

1. To replace the battery, slide off the battery cover on the back of the transmitter.
2. Insert a new CR2032 lithium battery, aligning the (+) and (-) markings correctly.
3. Test by pressing the ON or OFF buttons to ensure the LED lights up.
4. Slide the cover back onto the transmitter securely.
5. Do not dispose of batteries in a fire to prevent explosion or leakage.

FAQ

• Q: How do I dispose of used batteries?
• A: Remove and immediately recycle or dispose of used batteries according to local regulations. Do not dispose of batteries in household trash or incinerate them. Keep used batteries away from children as they may cause severe injury or death. Contact a local poison control center for treatment information.
• Q: What should I do if the battery compartment does not close securely?
• A: If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children. Always ensure that the battery compartment is completely secure to prevent any potential hazards.

Setup

• Plug the remote base into a grounded 3-prong outlet.
• Plug your electrical device into the remote base. Be sure that your electrical device is powered ON.
• Use the button on the remote control to turn your device ON and OFF.

Battery Information and Replacement
The remote control uses a 3-volt CR2032 lithium battery. To replace the battery, slide off the battery cover on the back of the transmitter. Insert a new CR2032 lithium battery, making sure to match up the (+) and polarity markings. To test, press the ON or OFF buttons to make sure the LED lights up. Side the cover back into the transmitter. DO NOT dispose of batteries in a fire. Batteries may explode or leak.

Specifications

• 3 3-wire Grounded Outlets and Plug
• Rated:125V 60Hz 8A 1000W Resistive or general Purpose, 5A 625W Tungsten
• 433.92Mhz frequency
• CR2032 lithium battery(included).

CAUTION: DO NOT splice, repair, or modify any part of this product. Unplug when not in use.
Fully insert the plug. DO NOT use if damaged. Inspect this product periodically. Use ONLY within the electrical ratings as marked on this product and package. DO NOT plug in more than a total of 1000 watts in this remote set. If the watts are not marked on your appliance, multiply the amperage rating (on the appliance nameplate) by 125 to determine the equivalent watts. Add determined watts for each plugged-in appliance or lamp (sum of watts on bulbs) to find the total watts being used.

• Only use CR2032 batteries and be sure to match the (+) polarity markings.
• Do not mix older batteries and new batteries from this product.
• Remove exhausted or dead batteries from the transmitter.
• Remove batteries if this product is not to be used for a long time.
• Do not dispose of batteries in a fire. Batteries may explode or leak. As with all small items, these batteries should be kept away from children. If swallowed, seek medical attention immediately.
• This product is a Radio Frequency Device (RF) and as such the range of the remote control is dependent on many unknown factors. Actual operational distance will vary depending on walls and line of sight obstructions, and other nearby electronic devices.

SAFETY PRECAUTIONS

1. Your remote control is powered by a 3V CR2032 battery(included). Remove the tab from the battery compartment of the remote control before use.
2. Ensure the batteries are installed correctly according to polarity (+ and -).
3. Do not mix old and new batteries, different brands or types of batteries, such as alkaline, carbon-zinc, or rechargeable batteries.
4. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.

WARNING

• INGESTION HAZARD: This product contains a button cell or coin battery.
• DEATH or serious injury can occur if ingested.
• A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
• KEEP new and used batteries OUT OF REACH OF CHILDREN.
• Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

NOTES

1. Remove and immediately recycle or dispose of batteries from equipment not used for an extended time according to local regulations.

2. Remove and immediately recycle or dispose of used batteries according to local regulations and keep them away from children.
   DO NOT dispose of batteries in household trash or incinerate them.

3. Even used batteries may cause severe injury or death.
   Call a local poison control center for treatment information.

4. Non-rechargeable batteries are not to be recharged. Do not force discharge, recharge, disassemble, heat above 60℃, or incinerate.
   Doing so may result in injury due to venting, leakage, or explosion resulting in chemical burns.

WARNING
INGESTION HAZARD:
This product contains a button cell or coin battery.

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses, and can radiateradio frequency energy and, if not installed and used under the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0cm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>