REDODO 12V 410Ah Lithium Iron Phosphate Battery User Manual
- August 23, 2024
- REDODO
Table of Contents
REDONDO 12V 410Ah Lithium Iron Phosphate Battery
PRODUCT OVERVIEW
BATTERY
- Combination: 12.8V410Ah
- Dimension: L20.47 W10.59 H8.66inch
- Plastic Shell Color: Grey + White
Terminal & Post Bolts
Terminal Size
M8 (1.25mm Metric Thread)
Post Bolts
M8 (1.25mm Metric Thread 16mm Bolt Length) (The bolts can be replaced with M8
bolts of other lengths based on actual needs.)
GENERAL INFORMATION
BATTERY-PACK MAIN PARAMETERS
- The maximum continuous current that the battery can withstand.
- The maximum continuous output power that the battery can support.
HOW TO ESTIMATE THE BATTERY CAPACITY
STATE OF CHARGE (SOC)
The battery capacity could be roughly estimated by its resting voltage (not
charging/discharging voltage)® Since the voltage of each battery is slightly
different, and the voltage measurement is affected by the measuring
instrument, ambient temperature, etc., the following parameters are for
reference only. The actual SOC of the battery is based on the discharge
capacity under load.
Resting Voltage: The voltage is measured after the battery has been
disconnected from the charger loaded with zero current, and left alone for 3
hours.
Based on the characteristics of LiFeP04 batteries, the voltage measured by all LiFeP04 batteries during charging/discharging is not the real voltage of the battery. Therefore, after charging/discharging and disconnecting the battery from the power source, the voltage of the battery will gradually drop/increase to its real voltage.
SERIES / PARALLEL CONNECTION
THE PREMISE OF CONNECTION
To connect in series or /and parallel, batteries should meet the below
conditions:
- identical batteries with the same battery capacity (Ah) and BMS (A)
- from the same brand (as lithium batteries from different brands have their special BMS)
- purchased in near time (within one month).
LIMITATION FOR SERIES/PARALLEL CONNECTION
Support connecting up to 4 identical batteries for up to 48V (51.2V) 410Ah
battery system (when in series)/ 12V (12.8V) 1640Ah battery system (when in
parallel).
WHAT TO DO WHEN THE BATTERY STOP WORKING?
It has an 85% chance that BMS has shut it off for protection, and you could
try one of the below ways to activate the battery.
General Steps
If the BMS has cut off the battery for protection, follow the below steps to
activate it.
If the battery is unable to recover itself after the above steps, please try activating by ONE OF BELOW TWO METHODS. After activated (voltage > 10V) and fully charged by the normal charging method, it can be used normally.
Method 1
- Use a charger with a lithium battery activation function to fully charge the battery.
Method 2
- Connect a controller that supports 12V LiFePO4 battery charging to charge the battery for 3~10s in sunny daytime.
PROVIDER
Shenzhen Maicheng Technology Innovation Co., Ltd.
MANUFACTURER CONTACT
service@redodopower.com
technicalsupport@redodopower.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>