Carrier X4 and Vector Air Chute Instruction Manual
- August 20, 2024
- Carrier
Table of Contents
Carrier X4 and Vector Air Chute
Product Information
Specifications
- Models: X4 and Vector
- Purpose: Guidelines for installing air chute for Prime applications
FAQ
Q: What should I do if I don’t have all the required parts?
A: It is essential to use all specified parts for proper installation. Contact your supplier for any missing parts before proceeding.
Carrier Corporation (“Carrier”) shall have no obligation or responsibility (including product warranty obligations) with respect to (a) any third-party components not supplied by Carrier, (b) non-compliant installations of Carrier components or (c) configurations of Carrier components that differ from Carrier’s recommended configurations. Further, Carrier provides these instructions as a courtesy only, and on an as-is basis. By using these instructions, you acknowledge and agree that use of these instructions is at your own risk.
Models: X4 and Vector
Purpose: The intent of this technical instruction is to provide guidelines for
installing air chute for Prime applications.
Required Parts
| Quantity | Part Number | Part Description |
|---|---|---|
| 2 | Customer Supplied | Spacer, Transition |
| 1 | Customer Supplied | Crossbar |
| 2 | Customer Supplied | Hardware, Spacer to Crossbar |
| 1 | Customer Supplied | Air chute kit (includes rivets) |
| 7 | Customer Supplied | Strip, hook/loop fastener 6.00” |
| 4 | Customer Supplied | Screw, #14×1” Hex Head Drill Point |
| 4 | Customer Supplied | Washer, Flat ¼” |
Air Chute Installation
-
Attach customer supplied transition spacer to front of trailer opening at locations shown.
-
Secure customer supplied transition crossbar to spacers with customer supplied hardware.
-
Secure air chute to transition crossbar as shown using self-drilling screws and washers.
-
Secure the front of the air chute to the front wall and ceiling of the trailer as shown with composite rivets. Measurements are the same for left/right side.
- A: 18” from ceiling, 13” from wall
- B: 13.125” from ceiling, 2.375” from wall
- C: 1.00” from ceiling, 13.125” from wall
- D: 21” from wall, 34” from front
Note: The chute should have enough excess material allowing it to touch the ceiling at the reefer unit when pushed up to ceiling.
-
Secure the air chute to the ceiling with composite rivets. Use the holes in the chute as a placement guide. Position the edge of the chute 21” from the sides of the trailer walls.
Note: Verify there is 4.50-5.50” drop from ceiling to centerline of chute at the transition to the end of the chute. -
Install 6.00” pieces of hook/loop fastener to ceiling of trailer at locations shown.
- A: Centerline of trailer/end of chute
- B: 21.00” from trailer wall/end of chute
- C: 21.00” from trailer wall/21.00”
Secure end of chute to hook/loop fastener.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>