MONSTER JAM 66816RX2G4 RC Spider Man Instruction Manual

MONSTER JAM 66816RX2G4 RC Spider Man

Product Information

Specifications

• Product Name: Spider-Man RC
• Power Switch: Yes
• Caution: 5V Power Supply Required

Product Usage Instructions

Power Switch Usage
The power switch controls the on/off function of the Spider-Man RC toy. To turn the toy on, flip the power switch to the “ON” position. To turn it off, switch it to the “OFF” position.

Charging Cable Compartment
The charging cable compartment is where you can store the charging cable for the toy. Keep the compartment closed when not in use to prevent dust and debris from entering.

Frequently Asked Questions (FAQ)
Q: What type of power supply does the Spider-Man RC toy require?
A: The toy requires a 5V power supply for operation. Make sure to use the correct voltage to avoid damaging the toy.

CAUTION: Not a ride-on-toy.

INSTRUCTIONAL VIDEOS

INDOOR / OUTDOOR

CAUTION: HAIR ENTANGLEMENT
Tie back and cover hair and secure loose clothing prior to play.

CONTENTS

• 1 Controller
• 1 Instruction Guide

HOW TO INSTALL BATTERIES

HOW TO CHARGE / CHARGE

HOW TO CONNECT THE CONTROLLER

DIRECTIONAL CONTROL

HOW TO FIX DRIFTING

HOW TO CLEAN WHEELS

HOW TO INSTALL BATTERIES

1. Press down on release button (A) to slide down battery cover (B).
2. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
3. Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.

HOW TO CHARGE

1. Turn the vehicle off.
2. Remove the cover from the charging cable compartment.
3. Plug the charging cable into a 5V DC computer outlet.
4. Pulsing ON/OFF LED indicates battery is charging, solid ON for fully charged.

HOW TO CONNECT THE CONTROLLER

1. Turn on the vehicle and place it on a flat surface.
2. Hold the controller near your vehicle, press the power button and wait until the power light stops flashing.
3. You are ready to drive. Use the remote control to drive.

CONTROLLER NOT CONNECTING

If your vehicle does not connect to the controller the first time, turn the vehicle off, remove batteries from the controller, put the batteries back in and repeat the HOW TO CONNECT THE CONTROLLER instructions.

NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

Safety Precautions:
Keep hands, hair and loose clothing away from the motor/ wheels when power switch is turned ON.

• Remove batteries when not in use. – Parental guidance is recommended for the play.
• Keep your toy in your sight so that you can supervise it all the time.
• New alkaline batteries are recommended to obtain maximum performance.
• Users should keep strict accordance with the instruction manual while operating the product.

Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.

CARE AND MAINTENANCE

Always remove batteries from the toy when it is not being used for a long period of time. Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat. Do not submerge the toy in water. This can damage the electronic assemblies.

SPECIAL NOTE TO ADULTS
Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the charger until the damage has been repaired. This toy is not intended for children under 3 years old. This toy must only be used with the recommended charger.

BATTERY SAFETY INFORMATION: Requires 2 x 1.5 V AAA (LR03) batteries. Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable-rechargeable batteries are to be removed from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

SPECIAL LITHIUM-ION BATTERY INSTRUCTIONS
Never charge battery unattended.

• Charge battery in an isolated area. Keep away from flammable materials. – Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or igniting. – Do not disassemble, modify, heat, or short circuit the batteries. Do not place them in fires or leave them in hot places. – Do not drop or subject to strong impacts. – Do not allow the batteries to get wet.
• Only charge the batteries with the specified Spin Master™ battery charger. – Only use the batteries in the device specified by Spin Master™. – Carefully read the instruction guide and use the batteries correctly. – In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. – Batteries must be recycled or disposed of properly.

PRODUCT BATTERY REMOVAL INSTRUCTIONS
Internal battery is factory installed and non-replaceable. Product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or deform product during disassembly. Ensure product is turned off, then use a screw driver to remove all screws. Separate product body halves to expose internal electronics. When battery is visible in its entirety use scissors to cut a single battery wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated, and the battery is free from the rest of the product. Dispose of battery in accordance with your local battery recycling or disposal laws.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>