MONSTER JAM 528730 Grave Digger Freestyle Force Remote Control Car Instruction Manual
- June 6, 2024
- MONSTER JAM
Table of Contents
NOSE WHEELIE BUTTON
TAIL WHEELIE BUTTON
BEGINNER MOD
WHEEL ALIGNMENT BUTTONS
ADVANCED MODE
CHARGING COMPARTMEN
POWER SWITC
For in-depth video instructions go to
INDOOR / OUTDOOR
WWW.MONSTERJAMRC.COM
WWW.SPINMASTER.COM
CAUTION:
HAIR ENTANGLEMENT —
Tie back and cover hair and secure loose clothing prior to playing.
1 controller
1 Instruction Guide
HOW TO INSTALL BATTERIE
HOW TO CHARGE
HOW TO DRIVE
MODE SELECTO
HOW TO STUNT
DIRECTIONAL CONTROL
HOW TO CORRECT WHEEL ALIGNMENT
HOW TO INSTALL BATTERIES
- Press down on release button (A) to slide down battery cover (B).
- Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
- Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.
HOW TO CHARGE
- Turn the vehicle off.
- Plug the small end of the charging cable into the charging port.
- Plug the charging cable into a 5V DC computer outlet.
- Blinking LED indicates battery is charging, solid ON for fully charged.
HOW TO DRIVE
- Turn on the vehicle and place it on a flat surface.
- Hold the controller near your Grave Digger® Freestyle Force™, press the power button and wait until the power light stops flashing.
- You are ready to drive.
- Use the remote control to drive.
TROUBLESHOOTING
NOTE : If your truck does not connect to the controller the first time,
turn the truck off, take the batteries out of the controller and repeat STEP
-
MODE SELECTOR
-
Move the skill switch to select either BEGINNER MODE or ADVANCED MODE.
-
BEGINNER MODE – speed is limited while in nose or tail wheelie for smooth driving.
-
ADVANCED MODE – speed is NOT limited while in nose or tail wheelie for stunt driving.
HOW TO STUNT
NOTE : FOR BEST STUNT PERFORMANCE MAKE SURE THE TIRES ARE CLEAN. If they
are dirty, wipe the TIRES gently with a clean damp cloth. DO NOT SUBMERGE THE
TOY IN WATER.
- Press the Nose Wheelie Button to balance on the front wheels and drive and stunt around.
- Tap the Nose Wheelie Button to bounce the truck on the back wheels.
- Press the Tail Wheelie Button to balance on the back wheels and drive and stunt around.
- Tap the Tail Wheelie Button to bounce the truck on the front wheels.
NOTE : If the normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If the normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.
Safety Precautions: – Keep hands, hair and loose clothing away from the
motor/wheels when power switch is turned ON. – Remove batteries when not in
use. – Parental guidance is recommended for the play. – Keep your toy in your
sight so that you can supervise it all the time. – New alkaline batteries are
recommended to obtain maximum performance. – Users should keep strict
accordance with the instruction manual while operating the product. Note:
Parental guidance is recommended when installing or replacing batteries. Under
the environment with electrostatic discharge, the toy may malfunction and
require user to reset the toy.
CARE AND MAINTENANCE: Always remove batteries from the controller when it
is not being used for a long period of time. Wipe the toy gently with a clean
damp cloth. Keep the toy away from direct heat. Do not submerge the toy in
water. This can damage the electronic assemblies.
SPECIAL NOTE TO ADULTS: Regularly examine for damage to the plug,
enclosure and other parts. In the event of any damage, the toy must not be
used with the charger until the damage has been repaired.
BATTERY SAFETY INFORMATION : Batteries are small objects. Replacement of
batteries must be done by adults. Follow the polarity (+/-) diagram in the
battery ompartment. Promptly remove dead batteries from the toy. Dispose of
used batteries properly. Remove batteries for prolonged storage. Only
batteries of the same or equivalent type as recommended are to be used. DO NOT
incinerate used batteries. DO NOT dispose of batteries in fire, as batteries
may explode or leak. DO NOT mix old and new batteries or types of batteries
(i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not
recommended due to possible reduced performance. Rechargeable batteries are
only to be charged under adult supervision. Replaceable-rechargeable batteries
are to be removed from the toy before being charged. DO NOT recharge non-
rechargeable batteries. DO NOT short-circuit the supply terminals.
SPECIAL LiFe BATTERY INSTRUCTIONS : Never charge battery unattended. –
Charge battery in an isolated area. Keep away from flammable materials. – Do
not expose to direct sunlight. There is a risk of the batteries exploding,
overheating, or igniting. – Do not disassemble, modify, heat, or short circuit
the batteries. Do not place them in fires or leave them in hot places. – Do
not drop or subject to strong impacts. – Do not allow the batteries to get
wet. – Only charge the batteries with the specified Spin Master™ battery
charger. – Only use the batteries in the device specified by Spin Master™. –
Carefully read the instruction guide and use the batteries correctly. – In the
unlikely event of leakage or explosion use sand or a chemical fire
extinguisher for the battery. – Batteries must be recycled or disposed of
properly.
PRODUCT BATTERY REMOVAL INSTRUCTIONS : Internal battery is factory
installed and non-replaceable. Product disassembly and battery removal must be
performed by an adult. Do not puncture, cut, tear, compress or deform product
during disassembly. Ensure product is turned off, then use a screw driver to
remove all screws. Separate product body halves to expose internal
electronics. When battery is visible in its entirety use scissors to cut a
single battery wire, immediately wrap the cut wire end with tape to isolate
it, repeat until all battery wires are cut and isolated, and the battery is
free from the rest of the product. Dispose of battery in accordance with your
local battery recycling or disposal laws.
Production Notes
Artwork serial (docket) :
T66808_0002_20130208_GML_IS_R5 (MJC_Grave_Digger_Freestyle_Force_F21)
Visual Branding Designer / Date : Carl Wang (04/12/2021)
- This contract proof is simulated ISO-G7 printing on CCNB.
- CMYK color on printing must closely match to this sheet.
- Pantone color must closely match to Pantone book.
- Print sample standard viewing condition is 5000°K light booth.
- Screen ruling 175 lpi or above.
- Die-line may be slightly different from the latest development, check with the product vendor or Spin Master.
- Die-line, placement line, and placement indicator do not print.
CONFIDENTIAL / UNAUTHORIZED USE PROHIBIT
Country of Origin – Placement
Factory according to production country to print Country of Origin (COO)
If the corresponding country is not in below, contact Spin Master to provide
translation
Spin Master Ltd. reserves the right to discontinue the MONSTERJAMRC.COM website at any time.
CONTAINS 1 x 6.4V/700mAh LiFe BATTERY PACK AND REQUIRES 2 x 1.5V AAA
(LR03) BATTERIES (not included). Batteries or battery packs must be recycled
or disposed of properly. When this product has reached
the end of its useful life, it should not be disposed of with other household
waste. The Waste Electrical and Electronic Equipment Regulations require it to
be separately collected so that it can be treated using the best
available recovery and recycling techniques. This will minimize the impact on
the environment and human health from soil and water contamination by any
hazardous substances, decrease the resources required to
make new products and avoid using up landfill space. Please do your part by
keeping this product out of the municipal waste stream! The “wheelie bin”
symbol means that it should be collected as “waste electrical and
electronic equipment”. You can return an old product to your retailer when you
buy a similar new one. For other options, please contact your local council
FCC STATEMENT:
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including
interference that may cause undesired operation. This equipment has been
tested and found to comply with the limits for Class B digital devices
pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against
harmful interference to radio communications. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio
communication. However,
there is no guarantee that interference will not occur in a particular
installation. If this toy does cause interference to radio or television
reception (you can check this by turning the toy off and on while listening
for the interference),
one or more of the following measures may be useful:
• Reorient or relocate the receiving antenna
• Increase the separation between the toy and the radio or the TV
• Consult the dealer or an experienced TV-radio technician for help.
NOTE:
Changes, adjustments or modifications to this unit, including but not limited
to, replacement of any transmitter component (crystal, semiconductor, etc)
could result in a violation of FCC rules under part 15 and/or 95 and must be
expressly
approved by Spin Master Ltd or they could void the user’s authority to operate
the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite
100, Williamsville, NY 14221. To contact the responsible party please visit
fcc.spinmaster.com
Shielded cables must be used with this unit to ensure compliance with the
Class B FCC limits.
Spin Master International B.V. hereby declares that the radio equipment type
MONSTER JAM Grave Digger® Freestyle Force™ is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at
the following internet address: http://doc.spinmaster.com
pin Master International
Frequency band(s) : 2.414 – 2.465 GHz / Maximum radio-frequency power
transmitted: <10 dBm
CAUTION : Hair Entanglement. Tie back and cover hair and secure loose
clothing prior to play.，
WARNING : CHOKING HAZARD-Small parts. Not suitable for children under
three years.
CONFIDENTIAL / UNAUTHORIZED USE PROHIBIT
Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221
Spin Master International B.V., Kingsfordweg 151, 1043 GR Amsterdam, NL
Spin Master Australia Pty Ltd, Suite 101, Level 1, 18-24 Chandos Street, St
Leonards, NSW 2065; 1800 316 982
Spin Master Toys UK Ltd. Secure Trust House, Boston Drive, Bourne End,
Buckinghamshire, SL8 5YS, UK
This toy is only to be connected to equipment bearing either of the following
symbols:
Before first use: Read the user’s information together with your child.
Before first use: Read the user’s information together with your child.
Retain this information, addresses and phone numbers for future reference
Do not change or modify anything on the toy a
Spin Master logo & © 2021 Spin Master Ltd. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>