MONSTER JAM GRAVE DIGGER RC Truck Instruction Manual

June 13, 2024
MONSTER JAM

MONSTER JAM GRAVE DIGGER RC Truck

MONSTER JAM GRAVE DIGGER RC Truck

Operating Instructions

Operating Instruction

A BOOST BUTTON
B DRIFT ADJUSTERS
C POWER SWITCH
D POWER LED
E CHARGE PORT

2xAAA (LR03) 1.5 V ,1.5 V
Not included

INSTRUCTIONAL VIDEOS!

Check with your parents. MONSTERJAMRC.COM

 INDOOR ONLY

CAUTION: HAIR ENTANGLEMENT — Tie back and cover hair and secure loose clothing prior to play.

CONTENTS

  • 1 Grave Digger TM

  • 1 Controller

  • 1 Ramp
    Package Content

  • 1 USB-C Cable

  • 1 Instruction Guide

HOW TO INSTALL BATTERIES

  1. Open the battery door with a screwdriver. If used batteries are present, remove these batteries from the unit by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
  2. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
  3. Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.
    How To Install Batteries

HOW TO CHARGE

  1. Turn the vehicle off.
  2. Plug the small end of the charging cable into the charging port.
  3. Plug the charging cable into a 5V DC computer outlet.
  4. Pulsing ON/OFF LED indicates battery is charging, solid ON for fully charged.
    How To Charge

HOW TO CONNECT THE CONTROLLER

  1. Turn on the vehicle and place it on a flat surface.
  2. Press any button on the Controller.
  3. You are ready to drive. Use the remote control to drive.
    How To Connect The Controller

DIRECTIONAL CONTROL

Directional Control

RAMP

Ramp

HOW TO CORRECT WHEEL ALIGNMENT

How To Correct Wheel Alignment

CONTROLLER NOT CONNECTING

If your vehicle does not connect to the controller the first time, turn the vehicle off, remove batteries from the controller, put the batteries back in and repeat the HOW TO CONNECT THE CONTROLLER instructions.
NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

Safety Precautions: –

Keep hands, hair and loose clothing away from the motor/ wheels when power switch is turned ON. – Remove batteries when not in use. – Parental guidance is recommended for the play. – Keep your toy in your sight so that you can supervise it all the time. -New alkaline batteries are recommended to obtain maximum performance. – Users should keep strict accordance with the instruction manual while operating the product.
Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.

CARE AND MAINTENANCE:

Always remove batteries from the toy when it is not being used for a long period of time. Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat. Do not submerge the toy in water. This can damage the electronic assemblies.

SPECIAL NOTE TO ADULTS:

Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the charger until the damage has been repaired. This toy is not intended for children under 3 years old. This toy must only be used with the recommended charger.

BATTERY SAFETY INFORMATION:

Requires 2 x 1.5 V AAA (LR03) batteries. Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable- rechargeable batteries are to be removed from the toy before being charged.
DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

SPECIAL Li-Po BATTERY INSTRUCTONS:

Never charge battery unattended. – Charge battery in an isolated area. Keep away from flammable materials. – Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or igniting. – Do not disassemble, modify, heat, or short circuit the batteries. Do not place them in fires or leave them in hot places. – Do not drop or subject to strong impacts. – Do not allow the batteries to get wet. – Only charge the batteries with the specified Spin Master™ battery charger. – Only use the batteries in the device specified by Spin Master™. – Carefully read the instruction guide and use the batteries correctly. – In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. – Batteries must be recycled or disposed of properly.

PRODUCT BATTERY REMOVAL INSTRUCTIONS:

Internal battery is factory installed and non-replaceable. Product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or deform product during disassembly. Ensure product is turned off, then use a screw driver to remove all screws. Separate product body halves to expose internal electronics. When battery is visible in its entirety use scissors to cut a single battery wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated, and the battery is free from the rest of the product. Dispose of battery in accordance with your local battery recycling or disposal laws.

 CONTAINS 1 x 3.7V/150mAh Li-Po BATTERY PACK AND REQUIRES 2 x 1.5V AAA

(LR03) BATTERIES (not included).

Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life, it should not be disposed of with other household waste. EU legislation for Electrical and Electronic Equipment and Batteries, requires these to be separately collected so that they can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.

Spin Master International B.V. hereby declares that the radio equipment type MONSTER JAM 1:64th Grave Digger™ is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://doc.spinmaster.com.

Do not change or modify anything on the toy.

Spin Master Ltd. reserves the right to discontinue the MONSTERJAMRC.COM website at any time.

Keep away from obstacles and electrical hazards

CAUTION: Hair Entanglement. Tie back and cover hair and secure loose clothing prior to play

WARNING: CHOKING HAZARD – Small parts. Not suitable for children under three years.
Symbol

Spin Master logo & © 2023 Spin Master Ltd. All rights reserved.

Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada

T66813_0001_20144706_GML_IS_R1
T66813_0002_20146572_GML_IS_R1
Symbols

Retain this information, addresses and phone numbers for future reference

Before first use: Read the user’s information together with your child.

This toy is only to be connected to equipment bearing either of the following symbols:

Frequency Band(s): 2 420 MHz – 2 465 MHz / Maximum radio frequency power transmitted: < 10dBm

Customer Support

Symbols

WWW.SPINMASTER.COM

Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals