Cross Mount 250 Intrepid Camp Gear User Manual
- August 16, 2024
- INTREPID CAMP GEAR
Table of Contents
Cross Mount 250 Intrepid Camp Gear
COMPONENTS
-
Top cross bar: 2ea
-
Spring washer: 16ea
-
Side bracket: 4ea
-
Torx plus T30 IP wrench: 1ea
-
M6 bolt torx head: 16ea
-
M6 T-nut: 16ea
SPARE PARTS:
Spring washer: 2 ea
M6 bolt torx head: 2 ea
M6 T-nut: 4 ea
INSTALLING THE CROSS MOUNT SOLO
- 4 T-NUTS INSERTION
Insert x2 T-Nuts into the groove of the top frame where you want to install
the Top Crossbar Side Bracket.
Insert x2 T-Nuts into the groove of the Top Crossbar.
- CROSSBAR & SIDE BRACKET ASSEMBLY
After mounting the side bracket to the crossbar, adjust x2 bolts and x2 washers as the picture shows, then tighten it into the T-nut.
- ASSEMBLY TO FRAME
Insert x2 bolts and x2 washers into the groove of the top frame as the picture shows, then tighten it.
- ASSEMBLY
To ensure that the crossbar is stable enough for you to attach the other side, we recommend attaching one side first
DIMENSION
Two indication lines have been etched on both ends of the top crossbar to make sure that side brackets are fully inserted when mounting. Lines should not be visible after assembly.