INTREPID CAMP GEAR GEO SOLO Rooftop Tent User Manual
- July 25, 2024
- INTREPID CAMP GEAR
Table of Contents
- Dimensions and Specs Geo Solo
- Hardware Components
- Crossbar or Platform
- Tent Components 
NEVER OPERATE THE TENT NEAR AN OPEN FLAMER OR HEAT SOURCE
At all times, take precautions that there are no flames, or other heat sources, near the tent fabric or mattress. Neither the tent nor the mattress are fire retardant.
NEVER USE ANY PRODUCT THAT BURNS FUEL IN THE TENT
Deadly fumes produced by stoves, lanterns, grill, heaters, or fire pits can build up inside of the tent and cause potential illness or even death.
Do not pull on the strut to enter the tent, and do not lean on the strut for back support. Any bend in the strut could make the tent non-functional and void the warranty.
We are not perfect, but we strive to be the best. Your feedback and improvement ideas will help us to reach this goal. Follow the setup instructions to get started, and if you need any help along the way, email us at support@intrepidcampgear.com
Dimensions and Specs Geo Solo
Interior Dimensions Exterior Dimensions
Note: Heavy-duty crossbars should be used when adding extra attachments on top.
Weight| + Mattress & condensation mat: 56kg (123 Ibs)
Tent frame & fabric: 52kg (114 Ibs) (excluding all detachables)
- Ladder: 7.5kg (16 lbs)
---|---
Interior Dimension| (L x W x H) 86.5″ x 31.5″ x 51″ (220cm x 80cm x
130cm)
Exterior Dimension| (L x W x H) 88.5″ x 33.5″ x 58″ (225cm x 85cm x
147cm)
Height closed/open| 7” (18cm)/58” (147cm)
Floor| Honeycomb aluminum
Tent Fabric| Body Skin fabrics
300D High Tenacity Double-Rip Polyester
+ 3000mm Poly Urethane Waterproof back coating
+ PFAS free water repellent surface coated
+ Flame Retardant treatment
+ Ultra-Violet resistant
Ceiling Fabrics
210g Breathable Polyester Cotton
+ PFAS free water repellent surface coated
+ Poly Urethane back coating
Mattress| + Skin – 210 Quilted Polyester fabric with PFAS free WR coating
+ Foam – 1.5″ (38mm) Poly Urethane, Poly Ethylene, Aluminum insulation triple layer body foam
+ Condensation Mesh – 0.75″ (15mm) Polyester coil spacer.
+ Total 2.5″ (63mm) Thick mattress
Seasons| 4 Seasons
Sleeping Capacity| 1 Adult
Hardware Components
Your GEO SOLO comes with attached latches, a ladder, and a mounting kit with:
-
Tent | x 1
-
Vehicle connection brackets Stainless steel lock plates | x 6 sets
-
Logo plate | x 1 set
-
Additional M6 T-nut | Nut x 4
-
Torx T30IP for bolt M13 | x 1
Slim combination spanner | x 1 -
Mattress (Included air-mesh) | x 1
-
Ladder bracket (1 set equipped on side door) Other Parts included x 1 set
-
8 step ladder 92” (2.3m) | x 1
-
Handle + bolts + spring washer x | 1 set
Crossbar or Platform
ADJUSTING THE CROSSBARS
Manufacturer recommendation: distance between crossbars should be 36″ (91cm)
minimum for more stability while driving. This distance is also recommended
between mounting points on platform racks.
PLATFORM RACKS
Platform racks can also be used, but may require alternate installation rails. Popular platform racks like Prinsu or Pioneer racks may require brand-specific mounting hardware or alternate methods of installation.
Any additional accessories on crossbar load specification.
Resources like etrailer.com, Rack Starz, and Rack Attack have experts on site that will be available to help assist you find the right rack system for your vehicle.
CROSS BARS:
We recommend you purchase heavy-duty, aftermarket crossbars with a dynamic
weight rating of at least 176lbs (80kg). Be sure to check your system’s weight
capacity and
factor in any other equipment or accessories you plan on mounting, to ensure
it meets the crossbar’s weight recommendation and original car maker’s roof
rail limit.
Tent Components 
Tent Installation 
Parallel with the crossbar. 
Parallel with the vehicle’s body.
Check balance from front & back side.
Mounting SOLO tent from one side of the vehicle and proper placement.
Hardware Preparation
Insert x4 M8 bolts into the C tube at the bottom of tent.
Adjust x2 M8 bolts on the 2 sides of the cross bar as the picture shows.
Insert the lock plate to the M8 bolts.
Tighten x2 M8 nuts into the M8 bolts within a 5°–15° plate angle (bolt might break when untightening nut). Mark the installation position, it will help monitor the original position.
IMPORTANT : Be sure to check the hardware (roof rail, crossbar, lock plate, etc.) after 10-20 miles after installation and after every trip off road to be sure it’s still secure.
Installing Rail Components
INSTALL THE HANDLE
We recommend installing your ladder hooks and handle on your vehicle after it is mounted, and the handle should be placed in front of the main door (balanced push-up force).
Insert x2 M6 T-Nuts into the groove of the top frame.
Move it to the position where you want to install the handle.
Install the handle, x2 spring washers and x2 M6 bolts, and tighten the bolt.
Note : T-nuts left unused in the groove will make more noise.
INSTALL THE LADDER
Hook the ladder to the bracket properly and adjust the angle so it is stable, and the lock is securely engaged (be sure to adjust height and angle, then lock).
Ensure that hooks on top inserted to the shaft! Pull down to open the ladder.
Hold outside and press the button to close the ladder.
For sliding-door vehicles, we recommend using the Mantis Claw Hook for ladder stand-off.
Note: Please see the caution labels on the ladder.
How to Open The Geo Solo 
How to Manage Geometric Door
MULTIPLE DOOR-OPENING WAYS:
- Completely open.
- Full open (don’t need to fold the door).
- Half top opening (ventilation) for raining season.
- Half side opening for snowing season.
Setup Inside the Tent
Front door: The three large windows can be rolled up and tied neatly with the string all together or single.
Put up the ventilation support bars – Should fold before closing! otherwise it will dent on TPU window.
How to Close The Geo Solo
The inner connector (2 elastic band system) helps the skin to fold neatly when you close the tent.
Caution!
Be aware that holding strap is highly elastic and once removed it can
discharge. Keep children away.
You can wrap it and store it in the pocket when not in use. Grab the string
and pull to fold the tent.
It is recommended that you do not close it too quick, so the inner air has
enough time to go out. 
When it’s nearly
closed, tuck in the fabric from three sides,
then put the string inside the tent.
After tent is closed, be sure to lock latches on both sides of the tent and check side gaps (water penetration path) on both sides.
Optional Item
- Shoes bag
- Organizer GEO SOLO
- Mantis claw hook
- Cargo net
- T-Slot loop
- Cross mount
Tent Care and Safety
TENT CARE
While it is not possible to make a tent that is 100% waterproof, the GEO SOLO RTT is designed to achieve maximum water resistance. We suggest the following precautionary measures to aid in this.
- Recommend to zip up based on closing guide; this will help to prevent water inside tent from effecting the mattress and skin.
- If the tent has been exposed to long periods of rain or snow, periodically open the tent for a few hours to evaporate any drop lets and moisture.
- At least 1or 2daysbeforeuse,open the tent and vents to make sure no moisture has accumulated before you leave for your next adventure.
SAFETY
- Check hardware after 10-20miles of initial driving and after every trip off road to ensure every connection is secured.
- If any noises or vibrations are heard while driving, check the angle of tent with manufacturer standards and the tents placement to ensure its level. If the back side of your tent is lower than the front, this can created rag force that can generate stress on cross bars at high speeds.
- Gas struts are NOT to be used as handles. Doing so may cause gas struts to bend or gas leaking. Breaks of this kind are user error, not covered by our warranty policy.
- Keep gas spring rod away from dust, dust and rust may cause gas leakage.
- Before each camping season, or after prolonged use, be sure to check all the screws
- underneath the tent along the frame. Screws may loosen over time due to vibration
- and gravity. Screws should be snug; but not overtightened. If you have any concerns
- please contact Customer Service at Intrepid Camp Gear.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>