SEALEY LED201G, LED401G LED Twist Rechargeable Inspection Light User Manual

SEALEY LED201G, LED401G LED Twist Rechargeable Inspection Light

Specifications

Model| Battery| Charging Time| IP Rating| LED Type| Lumen Output| Nett Weight| Operating Time
---|---|---|---|---|---|---|---
LED201G| 3.7V 0.8Ah Li-ion| 2hr| IP52| 1W SMD + 1W SMD Side(High/Low)/Top| (200/100)/100lm| 0.094kg| Side(High/Low)/Top – (2/4)/2.5hr
LED401G| 3.7V 2.0Ah Li-ion| 2.5hr| IP52| 2W SMD + 1W SMD LED Side(High/Low)/Top| (400/200)/100lm| 0.143kg| Side(High/Low)/Top – (2/4)/6hr

Product Usage Instructions

Safety

• Ensure the torch is fully charged before initial use.
• DO NOT turn the torch on when it is being charged.
• DO NOT shine directly into the eyes.
• DO NOT allow children to use the torch.
• DO NOT handle or move the torch while charging.
• DO NOT use if the battery, casing, or cable is damaged.
• DO NOT leave the battery discharged; recharge immediately and periodically.

Battery Safety

• DO NOT open, dismantle, or modify the battery pack.
• Avoid crushing, puncturing, or disposing of in fire or water.
• Avoid exposure to direct sunlight or moisture.
• DO NOT place the torch face down while in use.
• Use designated battery packs; recycle or dispose of used batteries properly.
• If electrolyte contacts skin or eyes, rinse thoroughly and seek medical attention.

Introduction

• First press: Low beam
• Second press: High beam
• Third press: switches on end torch
• Fourth press: switches everything off.

Charging (Fig.2)

• Open the cover on the side of the mini light.
• Plug the USB-C into a 5V USB outlet.
• Insert the Type-C connector into the charging port on the side.
• For a full charge, time is approximately 2 / 2.5hrs depending on the model.

Maintenance

• Keep Light Clean and Check for Damage Before Every Use
• If damage is observed, remove from use until the unit is repaired.

Frequently Asked Questions

Q: Can I charge the torch and use it simultaneously?

A: No, DO NOT turn on the torch while it is being charged to avoid potential risks.

Q: How often should I recharge the battery if I don’t use the torch frequently?

A: It is recommended to recharge the battery at least once every six months of non-use to maintain its performance.

• Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.
• IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
• USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
• FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

SAFETY

GENERAL

• Ensure the torch is fully charged before initial use.
• DO NOT turn the torch on when it is being charged.
• DO NOT shine directly into your, other person’s, or an animal’s eyes.
• DO NOT allow children to use the torch.
• DO NOT handle or move the torch whilst it is being charged.
• DO NOT use the torch if you suspect that the battery, the torch casing, or the cable is damaged. Consult your Sealey Stockist.
• DO NOT leave the battery in a discharged state, recharge the battery immediately. Before storage, fully recharge the battery, and subsequently recharge the battery at least once every six months of non-use.

BATTERY SAFETY

• WARNING! To reduce the risk of burns or fire.
• DO NOT attempt to open, dismantle, modify, or service the battery pack.
• DO NOT crush, puncture, short external contacts or dispose of in fire or water.
• DO NOT expose to temperatures above 40°C or below – 10°C.
• DO NOT expose to direct sunlight for long periods.
• DO NOT expose to moisture.
• WARNING! DO NOT place the torch face down while in use.
• Replace only with the battery pack designated for this product.
• Recycle or dispose of used batteries as stipulated by local regulations.
• If the electrolyte in the cells gets on your skin, wash thoroughly with water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.

INTRODUCTION

• Super bright SMD LED top light and SMD LED torch. The light body twists 360° and the light arm tilts 180° to provide light at any angle.
• Features a magnet on the rear and rubber rubber-covered magnet on the base, which allows hands-free operation.
• Lithium-ion battery for longer life, no memory effect, and a much slower discharge than traditional Ni-MH batteries.
• Easy-to-read charge indicator displays the battery level during use and while charging. Long operating times. Charges via a USB Type-C cable (Supplied).

SPECIFICATION

(400/200)/100lm
Nett Weight| 0.094kg| 0.143kg
Operating time| Side(High/Low)/Top – (2/4)/2.5hr| Side(High/Low)/Top – (2/4)/6hr

LED201G Shown

OPERATION

PRESS ON/OFF TO OPERATE (FIG.3)

• First press: Low beam
• Second press: High beam
• Third press: switches on end torch
• Fourth press: switches everything off.

CHARGING (FIG.2)

• Open the cover on the side of the mini light.
• Plug the USB-C into a 5V USB outlet.
• Insert the Type-C connector into the charging port on the side,
• For a full charge, time is approximately 2 / 2.5hrs. depending on the model.

MAINTENANCE

• Keep the light clean and check for damage before every use.
• If damage is observed, remove it from use until the unit is repaired.
• The battery is not designed to be removed.
• The battery fitted to this light is considered to be a consumable item and its ability to accept charge will reduce over time. We will warranty it against mechanical and electrical defects for one year, this does not cover fair wear and tear.
• If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances, we will not replace the battery even if it is less than one year old.

ENVIRONMENT PROTECTION

• Recycle unwanted materials instead of disposing of them as waste. All tools, accessories, and packaging should be sorted, taken to a recycling center, and disposed of in a manner that is compatible with the environment.
• When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REGULATIONS

• Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE).
• When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

BATTERY REMOVAL

• Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd is required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
• Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk www.sealey.co.uk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>