LAS 10103 LED Set of rear lights for trailer Instruction Manual
- August 10, 2024
- LAS
Table of Contents
© EAL GmbH, 10103, 04.2024
Art. no. 10103
Operating instructions
LED Set of rear lights for trailer, 12 V
WARNING
Read the operating instructions through carefully prior to initial use and
observe all of the safety notes!
Store the original packaging, the receipt and these instructions so that
they may be consulted at a later date!
Not observing such may lead to personal injury, damages to the device or
your property!
Prior to initial use check the contents of the packaging to ensure that
they are in perfect condition and complete!
1. INTENDED USE
The set of LED rear lights is used to equip car trailers with a lighting system. It contains the functions for indicator, brake light, rear light and license plate illumination.
2. SCOPE OF DELIVERY
2 x LED rear lights 1 x Installation instructions
3. SPECIFICATIONS
Dimensions: approx. 35 x 98 x 105 [mm] Voltage: 12 V DC
Weight: approx. 0.180 kg (per light)
Function: Indicator, Rear light, Brake light, License plate illumination
Threaded pin: M5 x 15
Distance between threaded pins: 55 mm
4. SAFETY NOTES
- Keep children away and do not permit children to use this device!
- Only use this product for the intended use!
- Do not manipulate or disassemble the device!
- For your own safety, only use accessories or replacement parts specified in the instructions or that the manufacturer has recommended!
- Prior to each journey, check the rear lights to ensure that they are fully functional.
5. INSTALLATION INSTRUCTIONS
Installation of the rear lights
Choose an appropriate location on the rear of your trailer to affix the rear
lights. Pay attention to the legal requirements. The rear lights may not be
attached to chassis parts or lift gates. When you have located an appropriate
position, check to ensure that no cables or other lines will be damaged when
drilling. Now drill three holes for each rear light, one above the other, in
accordance with the sketch.
Mount the lights in such a way that the license plate illumination points inwards in the direction of the license plate. Insert the threaded pins and the cable through the drilled holes, place the toothed washers and nuts on the threaded pins and tighten the nuts firmly.
Connecting the rear lights
Connect the individual cables of the LED rear lights, in accordance with the
colour table, to the cables of your trailer. Protect the connecting points
from damp, for example, using heat shrink tubing or high-quality insulation
tape.
| White | Earth |
|---|---|
| Red | Brake light |
| Yellow | Indicator |
| Black | Rear light/license plate illumination |
With some vehicles it is possible that the automatic trailer recognition system/ CAN bus does not recognise these LED rear lights and an error message is displayed. For information, consult your specialist workshop or the vehicle manufacturer.
6. MAINTENANCE AND CARE
Clean the rear lights with a soft cloth or sponge and water only. Do not use aggressive cleaning agents or solvents.
7. NOTES REGARDING ENVIRONMENTAL PROTECTION
The packaging is made up of environmentally friendly materials which may be disposed of via your local recycling points. Do not put electrical devices into the household waste. Electronic and electrical devices must be collected separately and sent for environmentally friendly recycling. Contact your community or town administration for information regarding the disposal of electrics.
8. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107, 42115 Wuppertal, Germany
+49 (0)202 42 92 83 0 info@eal-vertrieb.com
+49 (0) 202 42 92 83 160 www.eal-vertrieb.com