BLAUPUNKT TPM 124 Portable Air Compressor User Manual

BLAUPUNKT TPM 124 Portable Air Compressor

Safety Instruction

Please read these instructions carefully before using the product and keep it in a safe place. Noise in excess of 75dB is generated when the machine is operating. Please pay attention to the protection. The tube and the device may generate high temperature when the inflator is used for a long time. Please cool it down before use. This product is not a toy. Children are not allowed to use it.

Instruction Parts info

1. American Air Nozzle
2. Tube
3. Tube storage bin
4. Tube Interface
5. Heat Emission Holes or
6. LED Display
7. “+”Button
8. Light Button
9. “-“Button
10. USB connector
11. LED Light
12. Charging Input
13. Mode Button
14. Start/stop button

Please note

The illustrations of the product, accessories, user interface, etc. in the manual are all schematic diagrams for reference only. Due to product update, the actual product and the schematic illustration may be slightly different. Please consult the actual product.

Accessories

• Adapter for air nozzle french X1

• Air needl X1
  

• Charging Cord X1

• Swim Ring Nozzle X1

How to Operate

Battery capacity and charge display

The length of the power indicator shows different formats to indicate the remaining power:

• Four bars : 100% battery power, -Three bars: 75% battery power,
• One bar : power < 25%, charging is required

Charging

Please make sure to fully charge the device the first time you use it. Use the charging cable and connect it to the 5V USB charger (not included) to charge the device.
Battery indicator lights up when charging: Battery indicator flashes. Battery charge indicator four bars: fully charged.
Tip: The device cannot be used to inflate while charging

Switch On
Switch On
Pull out tube and long press “start-stop button” for three seconds to start the device. In the power-on state, long press the “Start-Stop button” for three seconds then device will automatically shut down. After the tube is pulled out, it can be turned on again by long pressing the “start-stop button”.

Connecting the nozzle to the tube

American Air Nozzle
Mountain bikes, electric bikes, motorcycles and cars will be equipped with American air nozzles. Inflation:
The American air nozzle can be directly connected to inflate.
Deflate: Use a suitable tool to press the gas needle inside the nozzle to release the gas

French Air Nozzle Adapter

Road bikes and individual mountain bikes will use the “French Air Nozzle Adapter” to inflate: unscrew the screw of French gas nozzle and connect the” French air nozzle adapter” to inflate. After the inflation is completed, turn the screw on the tire nozzle port tight.
Deflation: Unscrew the screw of the French gas nozzle and press the screw to release the gas.

Air needle

When inflating basketball, football and other balls, you need to use an “air needle”.
Inflation: Tighten the “air needle” and ” American air nozzle” and insert the needle into the air hole to inflate.
Deflate: Insert the “gas needle” directly into the air hole to deflate

Detect the tire pressure

When the device switching on, connect the tube to the tire which needs to be inflated, the number displayed on the screen means the current pressure.

Check the air pressure of several devices

To ensure safety, please check the inflation pressure of the inflated object by reading the instruction manual before inflating to avoid personal injury caused by over-inflation.

Car Tires

The pressure range of automobile, bicycle and motorcycle tires is marked on the sidewall of the tire. The guiding air pressure of the car’s tires is marked near the inner wall of the driver’s side door. Please refer to the car manual for more details on the inflation pressure.

Balls

Inflating pressure of football, basketball volleyball and other balls is marked around the air nozzle on the ball

Recommended inflating pressure list

12, 14, 16 inch bicycle tire
20,22, 24 inch bicycle tire
26, 27.5, 29 inch mountain bike tire
Mi Electric Scooter Tire
700C Clincher Bicycle Tire
700C Tubular Bicycle Tire| 45-50psi
30-50psi
40-50psi
45-65psi
45-50psi
100-130psi
120-145ps
Motorcycle| Motorcycle or Electronic Motorcycle Tire| 1.8-3.0bar
---|---|---
Cars| Car tire| 2.2-2.8bar
Balls| Basketball Soccer Ball Volleyball Rugby Ball| 7-9psi
8-16psi
4-5psi
12-14psi

Note: The recommended pressure range is for reference only. Please refer to the instruction manual of the inflated product

Default inflation pressure

Mode Change

Press the “Mode Change” button to navigate through the six types of mode conditions. Before selecting the appropriate air pressure units, a long press selects between “PSI”, “BAR” and “KPA
Zero Mode: The preset pressure can be freely set from 3 to 150 psi
Cycling mode: Default 45psi. Adjustable range: 30-65 psi
Motorbike mode: Default 2.4 bar. Adjustable range:1.8~3.0 bar
Car mode : Default 2.5 bar. Adjustable range: 1.8~3.5 bar
Balloon mode : Default 8 psi. Adjustable range: 4-16 psi

Default value Adjustment

After Choosing Mode, short press “+”or “-” to adjust preset pressure value. long press “+” or “-” to quickly adjust the pressure value
The flashing number indicates the preset pressure can be adjusted, while the non-flashing number indicates the real-time pressure

LED Light

Press “LED light” button to turn the light on or off. Turning on the light is helpful to connect the nozzle and other operations in a dark environment. long press the “LED light” to trigger the SOS signal.

Inflating

How to start inflating
Press power button to start inflating when you choose your default mode. The LED display will show air pressure change simultaneously During inflating, there will be 75-80 dB noise. Please pay attention to protection. Because of temperature rising. please don’t touch the tube when it has worked for long time.
How to stop inflating
The air compressor will stop inflating automatically when it reaches to default pressure. Also, you can stop inflating by pressing “Start/stop button” button during the process of inflating.
Special Remind
The pressure exerted on balls, game balls, swimming rings and other products is lower than that of the pump. Therefore, the inflation pressure cannot be automatically stopped by the preset pressure and should be used with caution. Battery and standby mode At full power, the continuous operating time without charging at 25℃ is about 30 minutes. An increase in pressure load and a lower temperature can lead to a low resistance.

Remove the nozzle

The air pipe temperature is relatively high after the air nozzle is unscrewed. Be careful of scalding when removing the air nozzle. There will be slight air leakage during disassembly. Please disassemble quickly to reduce air output.

Stop

Plug in the tube and turn it off. When the air compressor is on, press and hold the “start/stop button” to stop it or turn it off automatically without any operation within 3 minutes.

Warning

• This product is not a toy. It is not suitable for use by children. It is recommended for use from the age of 16. During inflation, keep children at a safe distance from the pump.
• The product has a built- in non-removable Lithium battery. It is forbidden to throw the product into the fire or throw it away carelessly. Lithium battery are at risk of fire. spontaneous combustion and explosion due to overheating, impact and water inflow. Please avoid exposure to the sun in the vehicle and other high temperature environments.
• The storage temperature of the product should not be lower than-10Coor higher than 45C°, too cold or too hot will shorten the product life and damage the built-in battery.
• Idle the product for a long time may damage the battery. It is recommen- ded to charge it at least once every three months.
• The product has a built-in DC motor, which may generate electric sparks during operation. Please do not use it in a flammable or explosive environment.
• Please shut down immediately if abnormal noise or high temperature occurs during working.
• Before setting the inflation pressure value, make sure to select the correct unit of measurement, otherwise it may cause accidents such as a puncture. Common unit conversion: 1bar=14.5psi,1bar=100kpa.
• Do not walk away during inflation and observe the inflation process to prevent the inflation pressure from being too high without setting the preset air pressure.
• Please use it in a dry and clean environment. The intrusion of sand and dust may cause damage to the product. The product is not waterproof, it is forbidden to wash with water.

NOTES:

1. Ensure the batter capacity is full enough
2. Check air leakage in the air tube
3. Check whether the inflated devices are leaking air
4. Check whether the connecting parts of both ends of the tube are tightened

Non-inflating|

1. Check whether the tube is pulled out, you can start inflation only while tube pulled out
2. Ensure the battery capacity is full enough
3. Check that the current tyre pressure is higher than the default

Unable to raise or lower default pressure| Check whether you are in incorrect situation mode, or select zero mode to adjust the inflating pressure in the range of 3-150 psi
The pressure is zero during infating| Low-pressure inflatable products such as balloons are not within the measurable range of the air
The device automatically shuts down after the air nozzle is screwed on| Long press the Start/stop button to switch on the device again
Air leakage| Tighten the nozzle
Can not be charged|

1. Check whether the charging cord is well connected
2. The battery is in the state of low capacity for a long time, and it needs a period of charging to display the charging statu

SPECIFICATION

out thread)
Nozzle size| American nozzle11X20mm
French nozzle11X15mm
Battery Capacity| 4000mAh(14.8Wh)
Operating Noise| 5V2A
Input Voltage and Current| Type C
Charge Port| <3 hours
Charge Time| ±2psi

After-sales service

This device is covered by warranty against manufacturing defects. This does not include mishandling and/or negligence on the part of the end user. In case you require assistance, please contact our after-sales service:

Customer Support

Blaupunkt Competence Center Car Multimedia & Foldable E-Bikes Evo-Sales GmbH Hastenbecker Weg 33 31785 Hameln/Deutschland

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>