Maisto 82731 Radio Control Vehicle Instructions

82731 Radio Control Vehicle
Instructions
2.4GHz R/c

Maisto Radio Control Vehicles

Please keep this owner’s instruction manual for future reference. It contains important information We reserve the right to improve/revise the product specifications without notice. Class 1 LED Product

Contents:

RC Vehicle x 1
Transmitter x 1
Owner’s Instruction Manual x 1

Battery Requirement:

Vehicle: 4 x 1.5V “AA” LR6/R6 Batteries.
Transmitter: 2 x 1.5V “AAA” LR03/R03 Batteries.

Battery installation for the Transmitter(Refer to Diagram 1)

1. Use a screwdriver to loosen the screw on the battery cover and to open the battery (Screwdriver is not included).
2. Install 2 new 1.5V “AAA” LR03/R03 batteries with correct polarity Oil as shown inside the battery compartment.
3. Install the battery cover and then tighten the screw on the battery cover.

Battery installation for the Vehicle: (Refer to Diagram 2)

1. Set the “power switch” on the vehicle to the OFF position.
2. Use a screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included).
3. Install 4 new 1.5V “AA” LR6/R6 batteries with correct polarity (4-1-) as shown inside the battery compartment.
4. Install the battery cover and then tighten the screw on the battery cover.

How to play: (Refer to Diagram 3, 4, 5 & 6)

1. Set the “Power Switch” on the controller and vehicle to ON position, the “Power LED” on the controller will flash less than 3 seconds then stay on, meaning the automatic frequency matching between the controller and the vehicle is completed.
2. If the “Power LED” of the controller flash for more than 3 seconds, switch off both the vehicle and controller, then turn them on again.
3. Pull the trigger on the transmitter to drive the vehicle forward. Push the trigger on the transmitter to drive the vehicle backward.
4. Turn the steering knob on the transmitter to steer the vehicle to right or left.
5. Press the button to control dump action.
6. If the vehicle does not run in a straight line, adjust the wheel alignment under the chassis.
7. Turn the switch of the controller and vehicle to OFF position when not in play.

Performance Tips:

1. Do not drive the vehicle on grass, sand, or go through water.

2. Do not drive the vehicle in windy or rainy weather.

3. Do not drive the vehicle into any hard object.

4. Keep fingers, hair, and loose clothing away from the vehicle.

5. The operating range can be affected by a variety of factors:
   a) Weak transmitter or vehicle batteries.
   b) Interference from other items that emit radio frequency signals such as another R/C item on the same frequency, CB radios, cordless phones, high voltage transmitters, etc.

6. Outdoor usage is recommended in order to get optimal control range.

Battery use:

1. Alkaline batteries are recommended.
2. Only batteries of the same or equivalent type as recommended are to be used.
3. Do not mix alkaline, standard, or rechargeable batteries.
4. Do not mix old and new batteries or different types of batteries.
5. Non-rechargeable batteries are not to be charged.
6. Rechargeable batteries are only to be charged under adult supervision.
7. Rechargeable batteries are to be removed from the product before they are charged.
8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
9. Remove all batteries from the product when not in use for a long period of time_
10. Exhausted batteries are to be removed from the product_
11. The supply terminals are not to be short-circuited.
12. Dispose of batteries properly. Do not dispose of batteries in a fire – it may cause them to explode or leak causing injury or damage.
13. Battery change must only be made by adults.

Cautions

1. Do not attempt to disassemble the products.
2. Do not operate the vehicle with same frequency with other players in same location. This will interfere and cause the vehicle to lose control.
3. Make sure the batteries are installed with correct polarity (±1-) as shown inside the battery compartment.
4. Remove the package, take out all accessories and assemble the product before giving it to children to play

Disposal of batteries

Batteries should not be disposed of in household waste. As the consumer, you are legally obliged to return batteries containing harmful substances and all other used batteries.
You can hand in your old batteries at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
****Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury

FCC Label Compliance Statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RSS-210 Compliance Statement:
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference;
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Troubleshooting:

Battery polarities are reversed
The wheels are obstructed by foreign objects| Replace with new batteries
Insert the batteries with correct polarities as shown on the battery compartment
Remove foreign objects on the vehicle/wheels
Drive Slow/Poor Turning Signal| Low battery level
The wheels are obstructed by foreign objects| Replace with new batteries
Remove foreign objects on the vehicle/wheels
Poor distance control| Low battery level
Strong interference of surroundings| Replace with new batteries
Move to a better location for playing

Maisto international, Inc., Fontana, CA 92336, U.8 A

www.maisto.com
MADE IN CHINA

Documents / Resources

| Maisto 82731 Radio Control Vehicle [pdf] Instructions
82731RC, PKG82731RC, 82731 Maisto Radio Control Vehicle, Maisto Radio Control Vehicle, Control Vehicle, Vehicle, 82731
---|---
| Maisto 82731 Radio Control Vehicle [pdf] User Guide
19160RCB, PKG19160RCB, 82731 Radio Control Vehicle, Radio Control Vehicle, Vehicle

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>