Zowill VE07-L Fingerprint Door Lock Installation Guide
- August 10, 2024
- Zowill
Table of Contents
Zowill VE07-L Fingerprint Door Lock
Product Specifications
- Latch x1
- Latch & Strike screws x4
- Strike x1
- Mounting Dust Cover Screw x2 x1(optional)
- Rear Lever x1
- Front Lever x1
- Door Thickness: 1-3/8″ to 2″ (35mm to 50mm)
- Backset Adjustment: 2-3/8″ (60mm) or 2-3/4″ (70mm)
Product Usage Instructions
Prepare the Door and Check Dimensions:
- Make sure the hole in the door frame is drilled a minimum of 1/2” (12.7mm) deep to allow space for the latch when the door is closed.
Latch Backset Adjustment:
Backset is the distance from the door edge to the center of the hole in the door. Adjust the latch to fit either 2-3/8” (60mm) or 2-3/4” (70mm) backset based on your door’s requirements.
- If backset is 2-3/8” (60mm), no adjustment needed.
- If backset is 2-3/4” (70mm), adjust the latch accordingly.
In-Swing Door: The angle of the latch faces outside. Ensure proper
alignment with the chiseled hole in the door frame.
Out-Swing Door: The angle of the latch faces inside. Align the latch
correctly with the drilled hole.
Test the Lever:
- With the door open, test the front and rear levers to ensure smooth operation. Rotate the base of the spindle to align it with the hole.
FAQ
Frequently Asked Questions
- Q: Can I use an electric screwdriver during installation?
- A: No, it is recommended not to use an electric screwdriver during installation to prevent damage to the product.
- Q: What door thickness is compatible with this product?
- A: This product is suitable for doors with a thickness ranging from 1-3/8″ to 2″ (35mm to 50mm).
- Q: How do I know if I need to adjust the latch backset?
- A: Measure the backset of your door; if it is 2-3/4” (70mm), adjust the latch accordingly. If it is 2-3/8” (60mm), no adjustment is necessary.
Thank you for purchasing our products. Please review this manual thoroughly before operating your device. All pictures in this manual are for illustration purpose only. Actual product may vary due to product upgrade.
Parts list
TOOL REQUIRED
- Do not use an electric screwdriver during installation.
Overview
Installation Instructions
Prepare the door and check dimensions
- Make sure the hole in the door frame is drilled a minimum of 1/2’’ (12.7mm) deep, to leave enough space for the latch to extend into the door frame when the door is closed.
Latch backset adjustment
-
Backset is the distance from the door edge to the center of the hole in the door.
-
The latch is provided with adjustable design which can fit either 2-3/8’’(60mm) or 2-3/4’’(70mm) backset.
-
If the backset of your door is 2-3/8″(60mm), no need to adjust the latch.
-
If the backset of your door is 2-3/4″(70mm), please adjust the latch.
Install latch and strike
IMPORTANT
- The latch should be aligned with the chiseled properly, make sure the hole in door frame is drilled a minimum of 1″ (25.4mm) deep.
Install front and rear lever
Test the lever
- Keep the door open, checking out front and rear lever to test if it works smoothly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>