Zowill G2 Smart Lock Gateway User Manual
- June 14, 2024
- Zowill
Table of Contents
Smart Lock Gateway
User Manual
Thank you for purchasing our products. Please review this manual thoroughly
before operating your device.
All pictures in this manual are for illustration purpose only. Actual product
may vary due to product upgrade.
SMART LOCK GATEWAY G2
Model: | G2 |
---|---|
Dimensions: | 70mm x 70mm x 26mm |
Network: | WiFi 2.4G |
IEEE standard: | 802.11 b/g/n |
Power interface: | Type-C USB |
Power input: | 5V/500mA |
Light Status
Pair with App
1. Open the App|
---|---
2. Tap on “ ” on the upper left corner of the screen|
3. Select [Gateway]|
4. Select [ G2 ]|
5. Plug in the Gateway and power it on|
6. While the light is flashing in Red and Blue alternately, tap on “+”|
7. Add Gateway|
8. Select the network and enter your Wi-Fi password.|
Notice
If the above process times out, please power off and try again.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Disclaimer
We continuously optimize products as new technologies and features are
developed. For this reason, we reserve the right to make alterations to the
products without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>