Zowill DK02A Fingerprint Door Lock Instruction Manual
- June 14, 2024
- Zowill
Table of Contents
Zowill DK02A Fingerprint Door Lock
Installation Instructions
Parts List:
Parts identification
Prepare the door and check the dimensions
- Measure to confirm that the hole in the door is 2-1/8″(54mm).
- Measure to confirm that the backset is either 2-3/8″ or 2-3/4″(60mm or 70mm).
- Measure to confirm that the hole in the door is 1″(25mm).
- Measure to confirm that door thickness is between 1-3/8″ to 2″ (35mm to 50mm).
Choose faceplate
Is the slotted hole centered in the doorhole?
Install latch and deadbolt
IMPORTANT : Keep the latch in an unlocked position before installation.
Install exterior assembly
- Route the cable below the latch.
- IMPORTANT : The bolt must be in the unlocked position. Note the horizontal orientation of the torque blade.
- Route the cable through the hole in the mounting plate.
- Secure the mounting plate with the supplied screws.
Install interior assembly
Do not load batteries until the lock is completely installed.
- Remove the battery cover.
- Connect the cable and ensure a tight cable connection.
- Rotate the Thumb turn in the vertical 1 position and insert the horizontal 1: orientation of the torque blade into 1, the interior assembly lock switch.
- Secure the interior assembly with the supplied screws.
- Test the lock by rotating the thumb turn to see if the bolt can be extended and retracted smoothly.
Detect left/right-hand door installation
IMPORTANT : This step is required and crucial for the lock after installation!
- While the door is open and unlocked, load 3AA batteries into the interior assembly.
- Press and hold the reset button on the interior assembly using the reset tool provided in the package.
- Keep holding the reset button, and load the last battery. Hold the reset button until you hear the long sound of “BEEP”. The lock will automatically go into locking position. This is for the smart lock to memorize the orientation of the door.
- Install strike on the door frame.
IMPORTANT : Make sure the hole in the door frame is drilled a minimum of 1″(25mm)deep.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>