DeerValley DV-1V032 Rectangular Ceramic Vessel Sink Installation Guide
- August 9, 2024
- DeerValley
Table of Contents
DeerValley DV-1V032 Rectangular Ceramic Vessel Sink
Specifications
- Product: Vessel Bathroom Sink
- Materials: Stone, Marble, Granite
- Recommended Sealant: Stone, Marble, and Granite Silicone Caulk or General Purpose Silicone Sealant
- Drain Opening Size: 1 3/4 inches to 2 inches
Product Usage Instructions
Prior to Installation
Before starting the installation process, please make sure to read the
installation instructions thoroughly. Use the suggested tools and ensure you
are wearing appropriate personal safety gear for protection.
Installation Steps
- Step 1: Place the vessel sink on the installation countertop and verify that it fits properly with enough space for the faucet installation.
- Step 2: Mark the drain hole location on the countertop using a pencil.
- Step 3: Cut the countertop to create the drain opening of the recommended size (1 3/4 inches to 2 inches).
- Step 4: Turn the vessel sink upside down and apply silicone to the bottom edge.
Frequently Asked Questions (FAQ)
-
Q: What type of sealant should I use for installation?
A: It is recommended to use a stone, marble, and granite silicone caulk or a general purpose silicone sealant for sealing during installation. -
Q: What tools are suggested for installation?
A: The suggested tools include safety glasses, pencil, tape measure, drill, level, thread sealant, and the recommended sealant for the vessel sink. -
Q: What is the recommended size for the countertop drain opening?
A: The recommended size for the countertop drain opening is between 1 3/4 inches to 2 inches.
INSTALLATION INSTRUCTION
Vessel Bathroom Sink
Prior to Installation
- Observe and comply with all building and plumbing codes.
- As our basins are handcrafted and dimensions are approximate, we recommend using the actual basin for the cutout.
- Use 100% Silicone (non-water based) for all installations.
- Ensure adequate space behind the basin for faucet and backsplash, including the full range of motion for faucet handles and spouts.
- Make sure a watertight seal exists on all drain connections.
- Do not place basin directly on floor. After unpacking, place basin on protective material such as packing materials.
- Remember to always use non-abrasive cleaners on DeerValley sinks.
General Recommendations:
Please read installation instructions thoroughly before installing the vessel
sink.
Be sure to use proper tools and always wear proper personal safety accessories
for your protection.
INSTRUCTIONS
SUGGESTED TOOLS AND MATERIALS
Sealant-We recommend the use of a stone, marble and granite silicone caulk or a general purpose silicone sealant.
WARNING:
To reduce the risk of injury or property damage, read and follow all of the
installation instructions before installing this product and wear safety
goggles. This product must be installed in accordance with all state and local
plumbing and building codes. Call a professional if you are uncertain about
installing this product properly.
INSTALLATION STEPS
Step1:
Place the vessel sink on the installation countertop and confirm the size of
the vessel sink is appropriate to ensure that there is enough space left
behind to install the faucet. Step2:
Mark the drain hole location on the countertop with a pencil. Step3 :
Cut countertop for drain opening. The recommended size of the countertop drain
opening is 1 3/4 inches to 2 inches. Step4:
Put the vessel sink up side down and apply silicone to the bottom edge.