RAVAK B570000001 SONATA Bath Handles Instruction Manual
- October 27, 2023
- RAVAK
Table of Contents
RAVAK B570000001 SONATA Bath Handles
MOUNTING INSTRUCTIONS FOR THE SONATA HANDLE
CONTENTS OF THE MOUNTING KIT – HANDLE
SONATA handle| 2 pcs
Galvanized screw M8x35| 4 pcs
Nut M8| 4 pcs
Galvanized washer| 4 pcs
This type of bathtub has been prepared by the manufacturer with pre-drilled holes for the installation of a handle and headrest.
The handle must be mounted before installation of the bathtub.
It cannot be mounted afterwards!
In the center of the side part of the bathtub there are 2 x 2 pre-drilled
openings (9mm in diameter) for the 2 parts of the handle.
With the flat side up, place the handle against the pre-drilled holes. It
should be seated to follow the shape of the bathtub.
After finding the proper position, check that the holes in the bathtub
coincide with the holes in the handle. If not, the handle can be slightly
pressed into the proper position. 
Before final placement of the handle, place a
small amount of silicone on the outer side of the holes, under the washers.
Put the handle in place and tighten the M8 screws and washers from the under
side of the bathtub. Tighten the screws normally. Over-tightening of the
screws can cause deformation of the handle.
RAVAK a.s., Obecnická 285, 261 01 Pøíbram 1, ÈR
tel.: 318 427 111, 318 427 200, fax: 318 427 269, 318 427 278, e-mail:
smith@ravak.cz, www.ravak.com
References
- RAVAK a.s. - Acrylic Bathtubs and Shower Enclosures
- RAVAK a.s. - Když koupelnu, tak RAVAK – české koupelny světového designu!
- RAVAK GESELLSCHAFT für Sanitärprodukte mbH - Das Badeerlebnis in Ihrem Badezimmer
- RAVAK a.s. - bañeras y mamparas de baño
- RAVAK Hungary Kft. - ha fürdőszoba akkor RAVAK
- Ravak Polska S.A. - dożywotnia gwarancja na wszystkie wanny. Kompleksowe wyposażenie łazienek.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>